hello
I like to know if possible which molecular methods to use to make higher tiger of recombinant vesicular stomatitis virus?
thanks for your help.
Using transfection ratio of 2:2:1 (HIV gag: gene: VSVG Env) into 293T cells, we were able to achieve higher titer.
thanks a lot for your help.
When we used 70% cell confluency we were able to achieve higher titer. And moreover you can always grow on large plates and concentrate using amicons (upto 2 folds)
hello, a protocol requires a strict carnivorous diet for laboratory animals, can this diet be applied to mice and rats for 2 months (cheese, cooked chicken meat, eggs + vitamins in water)? thank you
06 January 2021 4,066 3 View
Some publications which we upload in Research Gate receives citations but the same paper which has been listed in the Google Scholar doesn't show any citation .
01 January 2021 908 5 View
hello I would like to ask for help regarding calculation of dilution factor to get the amount of mycotoxin per gram of sample. the extraction protocol as fellow: -ground 5 g of sample with 25 mL...
29 November 2020 1,831 15 View
hello, I would like to know please, if there are cases in which we can observe an increase of catalase activity in mice treated with a therapeutic dose of immunostimulants? I did twice the...
28 September 2020 4,193 3 View
hello, I am working on the extraction of trichothecenes from the grain of wheat and I would like to ask how is it possible to calculate the concentration of toxin ug per gram of wheat? the...
17 March 2020 7,469 3 View
How I can get source code for 802.11a PHY layer in matlab without using simulink?
27 December 2019 2,191 3 View
I've been measured the percent of my concentration series (R2 = 0.998) but the data weren't covered value more than 50%. Should I repeat my experiment or I just extrapolate the regression...
29 July 2019 2,899 5 View
Combination of morphometric and colorimetric has been applied for feature extraction in detection algorithm. In noisy background, this CV technique facing wrong identification results as well as...
20 August 2018 845 6 View
Dear All, I have find the different equation as usually to use for dpph inhibition on extract. How to validate the result that the equation was correct Please check the equation formula on the...
03 May 2018 1,394 5 View
In cloud-based RAN (C-RAN), all the signal processing were transferred from the local or small cell base stations (i.e. Distributed D-RAN) to a centralized center to simplify the network...
05 February 2018 2,941 3 View
How to calculate the RMSD values for a MD simulation using MOE?
07 August 2021 0 0 View
When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.
16 June 2021 0 0 View
Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...
03 March 2021 5,978 5 View
I want to know which of the available Covid-19 Vaccines would elicit the best immunological response and why
02 March 2021 1,388 3 View
Hi, I am trying to construct a multi-layer fibril structure from a single layer in PyMol by translating the layer along the fibril axis. For now, I am able to use the Translate command in PyMol...
02 March 2021 4,569 4 View
Question to you and THEM, the New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before? There appears to be a core problem for...
02 March 2021 3,024 2 View