Could anyone please explain to me why, for the past month or so, even though my reads keep on rising, my RG score has dropped by - if my estimate is correct - from around 35. 2 to about 33. 1.
Best wishes, Paul
That brings clarity to bear. Thank you Michael.
In medicine, I think evidence-based research and - crucial, this - evidence-based practice is quite robust. Insofar as social scientific veracity is concerned, the wide range of variables does...
08 September 2017 8,085 6 View
04 May 2017 3,537 13 View
A few years ago, I reviewed the manuscript of a good article in which "wicked problems" were of central concern. Despite my best efforts, I was unable to figure out why the term "wicked"...
08 September 2016 2,397 1 View
I am writing a book on social pedagogy and social justice. I believe it is justifiable to regard some moral statements as irrefutably correct; transcendental, if you will. Such statements operate...
08 September 2016 9,205 0 View
07 August 2016 254 3 View
If the brain is anatomy and the mind is physiology (debatable, of course) then surely the diagnosis of psychosomatic disorders is an oxymoron. This forces the question of whether or not mind can...
07 August 2016 3,137 35 View
What comes to mind for me here is the debate on the use of arguably (?) life-saving medical data collected by Nazi doctors in concentration camps.
07 August 2016 8,425 73 View
Popper did not think so. However, I think that social scientific predictions can be plausible if long established prior and contemporary trends (income inequality as a predictor of variable...
06 July 2016 2,364 6 View
04 May 2016 7,522 2 View
There are those who argue that intellectual argumentation should be objective and, in that regard, value-free. I personally disagree but I recognize that my "opponents" have a point. Or do they?
02 March 2016 1,031 2 View
Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...
01 March 2021 2,327 1 View
Hello, I spin-cast two different polymers onto wafers and measure their height as a function of initial concentration. For polymer A, I have the weight-average molecular weight (Mw) as well as...
28 February 2021 7,882 2 View
I am trying to find how to know the density needed for a pva electrospinning in a 0.6mm neddle, the electrospinning will be from top to bottom and the problem I really have is the solution because...
25 February 2021 2,615 3 View
I would like to make a correction in a co-author in your paper which is wrong. This name is also in other papers of Kenton Ko. Zey Ko is not a Co-author . The correct name is Zdenka...
24 February 2021 3,476 4 View
Hello, I have run into an issue that has sparkled a debate at work: is the LLOQ/ULOQ impacted by injection volume under the following circumstances: 1) Same dilution factor of all samples 2)...
23 February 2021 9,159 3 View
I am trying with a Unet code ontained from net ...in tensorflow. When trying to predict the segmentation result with the trained and saved model with metric " iou" using "CustomObjectScope"...
22 February 2021 5,254 1 View
When I run the job for TS(QST3) in gaseous phase, it was completed without any error. But when I add water in CPCM model it terminated with an error: Inconsistency: ModMin= 2 Eigenvalue=...
21 February 2021 3,198 2 View
I was wondering if anyone knew how to perform the Haldane correction for SPSS (this is the definition of the correction -...
21 February 2021 2,882 1 View
Hi all, I have a question regarding calculations using the Pfaffl method. I have 3 groups per experiment: 1 control group (calibrator) and 2 treatment groups with 6 to 7 biological repeats per...
19 February 2021 8,351 2 View
hi everyone I am simulating a unit cell structure in HFSS using Flouquet port having two modes for absorption I have used this formula:- absorption=...
17 February 2021 9,178 2 View