Article Surface modification of sol gel TiO 2 surface with sputtered...
Thank you very much professor, the problem is that i had the nanopowder of TiO2 and i need to deposit
Dear Bouazza Asmaa, you can coated TİO2 via solgel method first. If they amorphous you will need annealed procces I recommend 500 degree about 90 mins (it depends for film thickness).
I have been doing the m6A dot blot for a while with no improvement, I am extracting the RNA, and I can see the dots although the three biological replicas give a different reading on the memberan...
10 August 2024 8,537 5 View
I synthesised a nanocarrier by conjugation MOF (MIL-100) with folic acid for use in chemotherapy but the samples didn't dissolve completely in aqueous solution or DMSO. Instead, they only...
19 July 2024 8,521 0 View
15 July 2024 2,414 1 View
When preparing hierarchical zinc oxide ananostructure, the energy gap measured by PL was equal to (3.26 eV) While the energy gap value was determined by UV-Vis measurements (3.5 to 3.7 eV)
26 June 2024 7,505 6 View
I just found many protocols but not specific for bacterial growth
30 May 2024 6,305 2 View
I have three nanogels.. The difference between them is the cationic monomer ratio... However, the test is giving me similar curve of the three formulations
27 May 2024 2,063 0 View
Hello, I was elaborating thin films from FeCl3 using a dip coater. These films were deposited on a glass sheet for 6 layers and then annealed at 500°C. However, XRD analysis did not yield any...
31 March 2024 9,412 3 View
I am trying to express m6A protein and a fluorescence one RFP in the piggyback vector. I was thinking first of using the P2A to separate between the m6A and the RFP protein but then I was afraid...
12 March 2024 9,713 0 View
I have synthesised a 100 nm sized cationic nanogel and I want to use it as a carrier for cisplatin and paclitaxel
03 March 2024 3,426 0 View
i'm preparing my protocol for master degree and it's my first time ,i need some help ,my reserch titel is "burden of mother in caring for child with colstomy"
02 March 2024 5,656 2 View
I am using Rhodamine6G as gain medium and silver nanoparticles as scatterers on a microscope slide and laser input 532 nm comes from above.
09 August 2024 9,894 2 View
I need a very narrow glass capillary for my research. How can I make a glass capillary with an inner diameter of around 200 to 500 nanometers?
08 August 2024 8,915 0 View
A fungal strain was treated with nanoparticles. We want to do an environmental SEM analysis. So could anyone share your views on preparing the sample? Thank you.
07 August 2024 5,307 1 View
I have been using paraffin, but the deposited ZnO still detach from electrode. What is the best binder to modify graphite paste electrode with ZnO nanoparticles?
03 August 2024 4,623 3 View
Hello, if you made a transwell assay where you incubate the cells with a nanoparticle-encapsulated drug and considering that in the oposite compartment you'll have both the free and encapsulte...
03 August 2024 2,730 1 View
Following curve related to Co0.6Mn0.4Fe2O4 Magnetic nanoparticles with extra phase a-Fe2O3. I will appreciate to help me to interpretation this spectroscopy, especially the blue line.
31 July 2024 9,138 2 View
I've attempted to use this method to synthesize copper nanoparticles. Copper nanoparticles can be synthesised using a variety of precursor materials. CuSO4, distilled water, NaOH, and EDTA are...
28 July 2024 8,025 3 View
How much volume of siRNA can I add to 2.5 mL of liposomes with a total lipid concentration of 10 mg/mL?
27 July 2024 6,920 1 View
Some of the techniques I am familiar with are standard. I would like to know which of the two methods under study is preferable, as well as the cost and list of particles and devices needed in...
22 July 2024 1,920 3 View
Is it the best optimization ratio based on experiments?
22 July 2024 8,169 0 View