Dear Respected Researchers,
Analysis of Structural Interactions between bone and bone screws.
I have generated the screw model and imported it to design modeler where I created the bone model and used boolean subtraction to create the screw imprint/threads inside the bone. On getting to the Set-up, the contact elements or connection is solid-to-solid and which gave me excessive stress Von-Mises stresses after running the simulation. I have tried to change it surface-to-surface, rigid-to-flexible contact elements on ANSYS Workbench but to no avail. THANK YOU!
Dear Muhammad, in Workbench is implemented a thread contact tool that can help you, instead of draw the thread. It is better define a surface-to-surface contact. Anyway if you draw the fillet I suppose you can define a frictional contact, with an asymmetric contact. Or maybe the load is too high. Rigid-to-flexible is not a contact property you can defined only by Joint connection: I'm not sure if you mean this.
- Badges
- Science topic