Dear Mwila

It might be helpful if you were able to upload the error message in a separate attachment. Currently I have not ideas what is going wrong. That will also help us find what the problem is.

Thanks

Raja

Hi Raja

Please find attached the screen shot of the error message.

Thanks

Dear Mwila,

Maybe this is the reason:

"Package ‘metrumrg’ was removed from the CRAN repository.

Formerly available versions can be obtained from the archive.

Archived on 2014-11-25 as requests to remove the dependence on the non-portable package 'fork' were not acted on for months. And the maintainer email address bounced."

Best regards,

Peter

Dear Mwila 

Thanks for getting back. I think you might have installed metrumrg package properly. However, I am not sure how was your nonmem installation done. Nonmem should be installed using nmqual for metrumrg to be useful. Do you know if you installed nonmem and nmqal ?

Also you can try findNonmemCommand and move forward after that. 

Thanks

Raja

Mwila,

Raja was correct.  You will need NONMEM installed using NMQual for metumrg to function to its full potential. It is available from the link below:

http://metrumrg.com/opensourcetools.html

Peter is correct, we pulled metrumrg from CRAN due to CRAN issues we were unable to control.  It is maintained (I am the maintainer) and available from Rforge using the link below:

https://r-forge.r-project.org/R/?group_id=1215

Regards,

Bill

Just don't and try Stan (http://mc-stan.org/), it's free and better!