How can use Origin 8.5 software to do analysis of interference fringes?

More Johnston K. Kalwe's questions See All

How to removal SDS/SLS from large quantities of water?

Hi all, I have a several gallons of water mixed with low percent SLS, how can i remove the SLS in a cost-effective manner.

24 June 2024 6,725 3 View

Culturing muscle cells in DMEM?

Hello everyone, I would like to culture muscle cells, specially Human Umbilical Aortic Smooth Muscle Cells (HUASMCs) in DMEM. There are various papers out there where this has been done, however,...

28 May 2024 1,398 0 View

Good references for conducting causal mediation analysis using time-to-event data?

I am looking for good references for conducting causal mediation analysis using time-to-event data. If you are aware of available code (SAS, specifically), that would be very helpful as well.

11 July 2023 700 5 View

How to use FDTD lumerical to design and simulate metalenses?

I have just started using FDTD lumerical! I need some guidance on the simulation part towards designing a metalenses for shaping the wavefront of input beam.

11 April 2023 6,024 2 View

Methods for calculating adjusted incidence rates using validation statistics?

I am looking for advice on methods for adjusting incidence rates based on data obtained from validation studies (i.e., sensitivity, specificity values). Any insight you can provide would be helpful!

05 December 2022 9,089 4 View

Can Reduced Major Axis regression be used to test slope and location differences across categories?

I am examining average maximum temperature data for a site in Western Australia that has relocated at least four times. Due to exposure problems, both temperature (y) and the covariate rainfall...

24 August 2020 8,124 1 View

How to best characterise a new salt?

I am wanting to synthesize a few aluminium salts. What is the best technique to characterise salts?

03 August 2020 8,815 4 View

Please could you take part in my study?

Hi! I hope everyone is well. I'm in need for some more participants for my study and I would really appreciate it if you could take as little as 10 minutes out of your day to complete it. All...

30 May 2020 6,637 2 View

How to measure extraversion and introversion?

Hello! I'm wondering if anyone can help me. For my masters dissertation, I am looking how personality, particularly extraversion and introversion, may impact on responses to several communicative...

13 May 2020 4,711 6 View

How to increase the thickness of rings on BLAST Ring Image Generator (BRIG)?

Does anyone know how to increase the ring thickness when generating BLAST Ring Image Generator plots? Thank you so much in advance!

18 March 2020 8,368 3 View

Problems about acousto-optic coupling in Comsol, how to check whether the moving mesh is correct?

I’m trying to reproduce the acousto-optic coupling simulation in the paper Frequency–angular resolving LiDAR using chip-scale acousto-optic beam steering. LNOI(lithium niobate on insulator) is...

13 August 2024 9,795 0 View

Best mask design for metal deposition aiming build a Perovskite solar cell device?

What types of mask designs for metal deposition, to be used in a PVD system, are best suited for perovskite-based solar cells?

31 July 2024 4,835 3 View

Can a Conventional 50W visible LED Lamp Emit UV Light?

I'm researching light sources and their UV emissions. I'm curious if a 50W, 7500K conventional LED lamp emits any UV light. I found that a 200W tungsten lamp can emit up to 1.5 mW/cm² at 350 nm....

31 July 2024 3,843 7 View

Is there a good macro photography kit for on-site metallurgical investigation?

I am looking to purchase a photography kit for onsite metallurgical investigations, such as capturing photos of worn areas, hot tears, cold tears etc. Could anyone suggest me a good...

22 July 2024 3,490 2 View

How do I monitor my CCTV camera in Bangalore from California?

I would like to know how do I monitor my CCTV camera at my home in Bangalore from my current location which is California in USA?

11 July 2024 831 0 View

How to detect crack wall uisng real time camera ?

Crack detection using Jestson nano board with real time camera

10 July 2024 6,283 0 View

What are the principles of physical chemistry?

what are the main points

10 July 2024 9,236 5 View

Is there any materials that can be as flexible and stretchable as PDMS, while also having a small linear thermal expansion coefficient?

For the PDMS material, it's linear thermal expansion coefficient is about 3.2*10-4/℃. The polyimide has a smaller linear thermal expansion coefficient like 2*10-5/℃, but it cannot be stretch. It...

04 July 2024 4,525 1 View

How to solve Bubble Error in fiber splicing?

I'm having a bubbling error while splicing 100/350 um optical fiber (core/cladding) on the Fujikura FSM100P+. I have tried some ways such as changing Prefuse power and Prefuse time but to no...

03 July 2024 7,463 6 View

How can I analyze thermal camera images to measure heat stress in dairy cows?

Hi, I am working on heat stress in dairy cows. In a recent experiment, we used a FLIR-T62101 thermal camera to take photos of the cows. One photo is attached. How can I analyze these images to...

30 June 2024 2,190 5 View

Alexander Malm

You can measure the intensity along a profile in ImageJ which is open source, and then you can extract the data and plot it in Origin.

Eugene A. Tikhonov

Dear Alex! Some useful details on the question You can discover in my paper (See attachment)

Johnston K. Kalwe

Dear Alex, Dear Eugene; thank you for your insights. I am helped.