How can report minimal inhibitory concentration (MIC), when you will count MIC of herbs extract?

More Farzad Sadri's questions See All

How to get "density" and "viscosity" for cavitation(water vapor) for cavitating Francis turbine?

Hello there I am simulating cavitation for a Francis turbine. Francis turbine is rotating with 826 rpm. I have two questions; 1- Vapor pressure for my case is 2100 Pascal, and Temperature is 25...

13 May 2024 4,403 7 View

How to avoid segmentation in Level Set Topology Optimization ( I would need to localize the variation of the level-set)?

Dear All, I am trying to converge on an optimal solution for a compliance minimization problem using a parametric RBF-based level set method. However, I have faced the following problem(s) for...

14 February 2024 9,511 0 View

How to model anchored cable bolts (passive bolts) in FLAC 2D 8.1 software?

I am investigating the impact of pretension effect around circular tunnels. How can I do my own modeling? 1- I want to excavate a tunnel. 2- I want to put a rock bolt or cable bolt in the hole 3-...

08 February 2024 7,166 1 View

What are the boundary conditions for a 2D Channel when we know pressure inlet?

Hello everyone I am working in a 2D channel where I know the inlet Pressure as a function of cosine, and out let pressure at atmospheric level. What should I use for inlet and outlet boundary...

26 November 2023 6,412 5 View

The results obtained from the analysis of my study show that the average and SNR are different, ?

The results obtained from the analysis of my study show that the average and SNR are different, which do you think I should report and what is the reason for this difference?

12 November 2023 7,073 0 View

How can I have smooth boundaries in topology optimization using level-set method?

I am working on topology optimization using the parametric level set method. Regardless of the methodology, I thought it might be a generic problem in Topology optimization with which many...

05 October 2023 2,725 4 View

How to prepare a distribution map of Fritillaria genus in the world?

Fritillaria is one of the largest genera of the Liliaceae family. There are about 170 taxa of this genus all over the world. These are mostly native to the temperate regions of the Northern...

03 July 2023 5,678 0 View

Can I use convergence behavior of residuals to predict if my flow is laminar or turbulent when I use steady state simulation?

Hello all, I am trying to predict Drag coefficient of an object(and I am not interested in the vortex shedding after my object, also I cant afford LES), so I decided to use steady state...

05 April 2023 1,357 0 View

laminar Flow over a sphere(laminar vs KOmegaSST simulation) in OpenFoam?

Hello all I am simulating flow over a sphere at Re = 881 where Drag coefficient must be almost Cd=0.5. I simulate it using both using laminar and Turbulent models(KOmegaSST). for laminar...

11 March 2023 9,341 3 View

How to calculate energy spectrum for a Homogenous Isotropic turbulence at specific time in a rectangular shape?

Hello all I have two questions; 1- First of all, is it possible to generate HIT inside a rectangle? If so, it is called HIT again? 2- if Nx=Nz but Ny is different, How can I calculate power...

12 January 2023 3,135 3 View

Strugglling with m6A dot blot any suugesstion ?

I have been doing the m6A dot blot for a while with no improvement, I am extracting the RNA, and I can see the dots although the three biological replicas give a different reading on the memberan...

10 August 2024 8,539 5 View

How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?

09 August 2024 7,718 0 View

The aqueous fraction of the hydroethanolic extract is showing the presence of palmitic acid. What is the mechanism responsible ?

Palmitic acid presence in aqueous fraction

05 August 2024 8,624 4 View

Which solvent is better to dissolve with secondary metabolites extracted from fungi?

I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...

03 August 2024 4,725 2 View

For systematic review data extraction, should I use ITT or PP analysis, and count all randomized participants or only those who completed the study?

I am conducting a systematic review and meta analysis; as I am extracting data I realized there is a consort diagram that shows the number of patients from randomization till end of the study. So...

01 August 2024 9,993 3 View

For the moringa oleifera extract using ethanol as the solvent,what is the alternative method to concentrate the extract other than rotary evaporation?

99% pure ethanol was used for maceration also alternate methods along with the temperature and time to concentrate the extract can be specified

31 July 2024 5,113 4 View

What are the factors that causes the sample to have higher efficacy at lower concentration?

We conducted an antibacterial study of a plant extract. Varying concentrations of crude extract were subjected to microbroth dilution assay. The result showed that only the lowest concentration of...

31 July 2024 8,666 3 View

What Are the Best Alternatives to the MTT Assay for Assessing Cell Toxicity of Colored Herbal Extracts?

I am currently investigating the cytotoxicity of a series of herbal extracts, and like many studies, I have been using the MTT assay to evaluate cell viability. However, I am encountering a...

31 July 2024 193 4 View

How can I extract my bibliography from researchgate ?

how can I extract my bibliography from researchgate ?

28 July 2024 6,737 1 View

Is it necessary to attach fluorophore at 3' end in MIC RT PCR machine for Dual hybridization Probe designed especially for genotyping assay?

I designed 2 dual hybridization probes for my single SNP. where I attach my fluorophore 5'-FAM-nnnn-BHQ1-3', and 5'-HEX-nnnnnn-BHQ2-3'. I need to run it on the MIC RT PCR machine by Biomolecular...

28 July 2024 5,658 0 View

Yehia A.-G. Mahmoud

This paper will be helpful:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC4378808/

Shrinath Baliga

Whether it is herbs or single compounds the methodology interpretation and representation is same. The only factor to be important here is that you should have appropriate positive (known antibiotics) and negative (placebo) controls included

Vahid Pezeshkpour

hi.

I hope the text of this article will help you.