I'm trying to mesh one circular column into 3 sizes (top, middle, and bottom parts) by using Partition, seed each cell by different size, but some irregular mesh elements appeared even I used regular size for middle part as shown in two pictures below. It seems the mesh sizes for bottom and middle are trying match each other. I'm wondering if I create each part individually and merge them together after meshing each part separately, does that work? Could anyone help me regarding that?
Thanks
Dear A. Al-Kaseasbeh
If you mesh your model by sweep method and use quad elements, you can mesh all parts of model regularly as attached photo.
Dear Jiangbo Bai,
I tried this before asking the question here, but still It cannot give very nice mesh. Sayyed Behzad Abdellahi's suggestion is the best here.
You first creat three parts independently and assembly them. Then you can respectively mesh them as you wish. Last use the Tie constraint to connect the edges between the three parts.
Jiangbo Bai method may be useful since Abdellahi's method might give you a rectangular mesh (on coarser mesh side) with aspect ratio of 2. However as far a tying is used, user has more freedom to mesh independently without setbacks.
- Badges
- Science topic
- Similar topics
- Linguistics
- Philology
- Classical Philology
- Manuscripts