How much required quantity of Soil for testing Electrical conductivity of soil ?

I have no guide line about soil testing . my requirement is to know the actual concentration of soil for testing Electrical conductivity of soil. i got the following result . 2gm soil / 100ml= EC...

05 June 2018 7,948 0 View

What is the main solvent for dilution in Gas chromatography ?

If I want to test methanol by gas chromatography which solvent should be used for dilution ?.

31 December 2017 1,347 4 View

What is difference among flame mood, hydride generator, graphite furnance in AAS ?

i want to know the specefic difference among flame mood, Hydride generator , and griphite furnance in Atomic Absorption Spectrometer.

11 December 2017 8,414 3 View

What is the test parameters of soil sample?

in water we have to check pH, EC, TDS, BOD. COD, Havy metals, and many other things. what is the parameter of soil sample and reference value from guide line.

11 December 2017 6,802 9 View

Formula of HPLC area

07 August 2016 3,754 3 View

What are the new 2D nanomaterials were used for Silver nanoparticles stabilization?

In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...

01 March 2021 2,207 3 View

Can I run spearman's correlation on non monotonic data? Is it advisable?

Hi all, I am running a partial correlation analysis on mood data. I want to see if there is a correlation between scores on a novel hypomanic mood scale and existing measures of hypomania - the...

25 February 2021 1,619 3 View

How does charge on working electrode changes with rising potential?

During performing CV of a GCE or modified GCE, we rise the potential in the first half of the cycle and reduce it in reverse half. During the first half, what is the nature of charge on GCE or...

25 February 2021 7,994 3 View

How to delaminate copper in water-based anodes?

Hello everyone, I'm looking for a way to delaminate copper current collector of water-based anodes in Li-ion batteries without damaging the graphite film. I tried different materials such as HNO3...

24 February 2021 3,785 3 View

Thermal reduction of graphene oxide.?

I am trying to reduce graphene oxide by thermally but I have no proper information regarding this. Can any one help me regarding the details about temperature and time for the reduction of...

23 February 2021 4,155 4 View

What kind of steel moulds are used for hot pressing metal powders?

My main concern is that the metal powders should not weld to the mold surface and I should easily be able to eject out the pressed samples. I am looking for alternative for graphite moulds. The...

22 February 2021 2,965 4 View

How to Study a proton NMR of Graphene prepared by Electrochemical Exfoliation technique?

I performed a Proton NMR of graphene powder prepared by electrochemical exfoliation technique. It shows some peaks. But I can't understand it.

21 February 2021 8,947 3 View

Interpretation of a fluorescence Emission spectrum ?

Hello, i work with a spectrometer which only render the fluorescence emission spectrum. Until now i just found how to interpret an exitation- and emission spectrum together to generate deeper...

20 February 2021 1,291 3 View

Which compound is getting oxidized during bulk electrolysis with TFAA?

The experiment is really simple. When I do a bulk electrolysis with 1% TFAA (ACN solution) to get dihydrogen, what is going to be oxidized? (working electrode graphit, counter electrode platinum,...

18 February 2021 4,430 1 View

What is the best substrate for exfoliating few layers of hexagonal boron nitride (hBN) using traditional scotch tape method?

Unlike graphene, it is usually very difficult to exfoliate few layers (~10 nm thick) of hBN on SiO2 substrate due to lip-lip interaction at the edges. Au substrates have been proven very useful...

16 February 2021 2,635 2 View