My problem got aborted and the warning message shows "3 nodes have dof on which incorrect boundary conditions may have been specified. The nodes have been identified in node set WarnNodeBCIncorrectDof"..... how can i find the node set WarnNodeBCIncorrectDof from ABAQUS?..
Go to the vewer (postprocessor) open the display group manager, choose node sets to display and click on the set name WarnNodeBCIncorrectDof.
You may need to check the "highlight in viewport" box; then the nodes in the set will be marked as red dots.
Go to the vewer (postprocessor) open the display group manager, choose node sets to display and click on the set name WarnNodeBCIncorrectDof.
You may need to check the "highlight in viewport" box; then the nodes in the set will be marked as red dots.
open the odb file and expand the tree in the left and fine node sets then you will the set you want
When the Job is aborted due to error and the error nodes are created, how could it be found out? As the ODB file could not be produced due to errors??
Abaqus should write an odb if there are just wrong bc or so.If no odb is written, there must be some other mistake preventing that.
hi all, How can I fix the model in the nodes for the warning "WarnNodeBCInactiveDof." ?
- Badges
- Science topic