Hello Everyone I want to simulate a heterogeneous material and i want to simulate the empty space of the material. I want, if possible, generate various datum points to cut the geometry in the Assembly Model.
Thanks
Have you checked abaqus scripting manual? if these are few, you could create manually, otherwise use script
mdb.models[...].rootAssembly.DatumPointByCoordinate((x,y,z))
Thanks very much...I´m trying to model a porous material and I will import the geometry of Autocad.
Hello I´m trying to use some contact model in abaqus for represent the interaction between mastic and the grains?I´m using a viscoelastic model (Prony Series) for mastic and considering a rigid...
10 November 2016 8,864 2 View
Hello I´m trying to model a static Creep test in Abaqus. With serie the prony I could reproduce the total strain but I need also reproduce plastic strain. Any idea? very thankful
06 July 2015 8,355 2 View
Hello I´m trying to make a Subroutine in Abaqus. I have doubts about linking version of the softwares. I have Abaqus 6.13, Visual studio 2010 and Intel Visual Fortran Compose XE 2011.5.221 But I...
04 May 2015 3,167 10 View
I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?
11 August 2024 3,115 1 View
I am developing a predictive model for a water supply network that involves 20 influencing points. However, I only have historical data for 10 out of these 20 points. I would like to know how to...
10 August 2024 4,005 2 View
Usually, additive manufacturing techniques like SEBM, SLS, and SLM are used for interconnected porous lattice structure generation with sizes of >100–200 micrometers. Can the Fused Deposition...
09 August 2024 7,892 0 View
I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...
09 August 2024 5,048 2 View
I have input a moment load in module load Abaqus, i put my moment load on the node surface (using reference point). I have define moment in history output and make a set for moment too. But the...
08 August 2024 4,831 4 View
I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...
08 August 2024 719 0 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,028 0 View
Dear fellow researchers, I am currently working on a paper where I need to provide a reliable reference that defines and distinguishes between 3D mesh models and 3D city models. Although I am...
06 August 2024 9,986 2 View
I am working on Abaqus/Explicit(Quasistatic ) for the deformation of the auxetic structure model. Please explain how the plastic input value should be considered from the true stress-strain curve...
05 August 2024 454 3 View
I am seeking experimental or applicable data for the liner (LLDPE) interface in FLAC3D numerical modeling of a large stockpile. Could you please recommend suitable references? The preferred data...
05 August 2024 3,665 0 View