I faced a problem about my CFD model in a large two-stroke marine diesel engine in ANSYS Forte. Now, I try to validate this model with experimental data, but I can't converge with experimental data up till now. What can I do for converging simulation data with experimental data. Simulation was started by expansion process (to end combustion). Firstly, I am studying a large two-stroke marine diesel engine cold flow simulation (combustion process is not paid attention). I am sending a figure to express this circumstances. How can you introduce initial and boundary conditions? How can I converge simulation cylinder pressure data to experimental cylinder pressure data?
Thank you for your help. Best Regards
Could you show a chart with pressure data from simulation and experiment?
As foe the convergence,
have you tried with the element type and the element number?
- Badges
- Science topic