20 July 2016 0 6K Report

We establish fibrosarcoma in mice by inoculating tumor cells. Now we want to know cancer cell line TID50. 

More Saiedeh Razi's questions See All
How to perform wavelet transformed Granger causality tests in Matlab?

..

23 July 2024 6,018 4 View

Challenges in Identifying Crack Initiation and Interpreting Results in Abaqus Direct Cyclic Fatigue Simulation?

Dear researchers, I'm currently conducting a direct cyclic fatigue simulation in Abaqus, but I'm encountering difficulties in analyzing the results. Despite the simulation running, I'm struggling...

04 May 2024 6,957 2 View

Hello! Has anyone experienced simulating the effect of the number of layers on the tensile and bending properties of a material?

I have simulating the effect of numbers of layer on tensile properties of SLM manufactured titanium on Abaqus. I have used various simulation methods but i didn't see more than 2 results: The...

15 August 2023 5,190 2 View

Round down duplication number to the nearest integer in HFSS?

Hello everyone, Has anyone had experience rounding down a duplication number by formula to the nearest integer in HFSS?

08 June 2022 4,690 2 View

Duplicate an object along arbitrary line in HFSS 2020?

Hello everyone, How can I duplicate an object along the arbitrary line in HFSS 2020? it seems HFSS 2020 doesn't have a duplicate along line duplicate an object along the arbitrary line in HFSS...

06 June 2022 5,752 5 View

Why does my protein precipitate after dialysis?

My protein forms a loose debris after dialysis, which reduces its performance. What can be done to prevent this?

03 June 2022 7,011 1 View

Can anyone help me?? why after solubilization of decellular ECM, as soon as it placed in crosslin solution, it disintegrate?

In solubilization of decellular ECM process, after dissolving the decellular powder in pepsin and then adjusting its pH and lyophilizing the scaffold, as soon as the scaffold is placed in the...

17 September 2021 6,340 2 View

Which is the best mode in AFM to measure the surface roughness of ultra-smooth thin film which have roughness < 2 nm ?

I am using Bruker diamension icon. I would like to measure the surface roughness of ultra-smooth quartz substrate. I tried with Scansyst mode as well as contact mode. Scansyst shows a high force...

15 August 2021 4,113 9 View

How to choose best RCM ensemble for hydrological modeling ?

I'm working on the impact of climate change on water resources. how to choose the best ensemble from RCM projected rainfall? what method I should use to compare different RCM and choose the best...

17 March 2021 5,352 8 View

Can anyone provide me the Shapefile of indo-burma biodiversity hotspot?

To prepare a map of an article I need the shapefile of the indo-burma biodiversity hotspot. Can anyone help me with this?

31 December 2020 4,308 12 View

Similar questions and discussions
Why Do TDS and EC Increase with Larger Wastewater Volumes, While BOD and COD Decrease?

I have carried out MFC experiments on three different volumes, 50, 500 and 1000 mL of wastewater. Results after MFC treatment shows that TDS and EC are more in larger volumes of water i.e. TDS and...

09 August 2024 9,621 0 View

Could it be a cell culture contamination?

Hello everyone! I observed in my culture (htert-RPE1 cells) an orange- red particle at the bottom of the dish. It is visible to the naked eye as a very very small red dot. Could it be a...

09 August 2024 2,824 3 View

Is there any way to quantify bacterial and fungal cells in their mixed culture?

I am working in fungal fermentation of soybean meal and there is bacterial growth in them at times. I am trying to quantify fungal cell counts and bacterial cells; but I haven't been able to do at...

07 August 2024 7,535 4 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,106 4 View

Why activated CAR-Jurkat cell could not kill targets?

Previously when I co-coluture anti-CD19(FMC63) CAR-Jurkat with Raji with E:T=5:1, Jurkat can eliminate Raji in 24h. However, when I test another CAR construct, although I can dectect totally CD69...

06 August 2024 641 2 View

Are there instances where molecules with larger molecular weights exhibit greater mobility than those with smaller molecular weights?

Hi, I know that low molecular weight (MW) molecules generally tend to have higher mobility, while high molecular weight molecules tend to have lower mobility. However, in my experimental...

06 August 2024 1,495 2 View

Weak DAPI staining after immunohistochemistry - how to improve?

After immunohistochemistry of previously fixed in PFA and EtOH and then frozen 20 μm sections of zebrafish brain, DAPI staining is very weak (right) compared to the same sections stained without...

05 August 2024 9,637 2 View

The Curse of Evolution and Complexity?

Brain and body mass together are positively correlated with lifespan (Hofman 1993). The duration of neural development is one of the best predictors of brain size, and conception is the best...

05 August 2024 6,247 3 View

For an in-vitro drug release study, what molecular weight cut-off (MWCO) dialysis bag is required for a 117 kDa protein?

kindly reply me. Thanking you in advance.

05 August 2024 7,727 4 View

How to isolate lymphocytes from mouse spleen?

I have tried several times to isolate lymphocytes from mouse spleen, but all attempts have been unsuccessful. I tried most available protocols. I used different dissociation media (HBSS with Ca...

04 August 2024 9,913 7 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close