22 November 2020 0 5K Report

,i'm simulating a planing hull in starccm i have defined a 0.3 seconds release time,time step=0.01,but i have tried different time stepes like 0.001 and also 0.0001 but the result was same and also i have decreased the size of mesh in vertical direction but it wasn't useful .Before running the simulation i checked the mesh and geometry and there wasn't any cells with negative volume or pierced faces but just after the release time an error occours :"Error in metrics computations.The mesh may have non-positive volume cells.This may be due to an invalid imported mesh or to errors intializing an interface.Repair the mesh before proceeding." I need some guidanc,thanks.

More Hamed Amoun's questions See All
Similar questions and discussions