11 November 2016 3 8K Report

I was exfoliated graphene on ITO substrate..  During taken my Raman spectra its showing weird to me... I mostly got the G peak was more intense than the 2D even for the mono layer. Instead of getting a sharp 2D peak , I got less intense 2D peak than G one. And shape of the 2D peak is not showing me as i read from the literature's.. Whether i measured on right mono layer or is it any charging (or)  doping ??

More K. Sampathkumar's questions See All
Does any TMDC monolayer(attached with bulk portion) heterojunction could give us unique IV, and transport characteristics than normal one ?

Greetings, TMDC mono-layer hetero junction I made by transferring of each flake (mono-layer attached with bulk portion) on gold contact fingers(bottom electrode contacts made on 300nm SiO2...

01 February 2018 7,501 1 View

What are the consequesnces could possible on electrical transport in 2D TMDC layer, Especially the case where Monolayer attached with bulk portion ?

Greetings, TMDC mono layer has been connected with one of the electrode and the bulk part which is attached with mono layer was connected with the counter electrode. What could be...

01 February 2018 1,011 1 View

Dear Seniors, i have an query on 2D and 1D crystal growths

I would like to establish growing of 1D nano wires on 2D TMDC materials (integrated system, 1D and 2D) at low-temperature chemical bath synthesis. The cruciality is nucleation of 1D structure on...

07 August 2017 8,612 0 View

General Question about interpreting the scientific data against the proposed phenomena by other scientist !

Sometimes researchers getting new results out from the similar experiments done by other researchers. But, if they propose some new phenomena against the existing one, the scientific community is...

01 January 1970 9,306 7 View

Similar questions and discussions
Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

What are the new 2D nanomaterials were used for Silver nanoparticles stabilization?

In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...

01 March 2021 2,207 3 View

Why initial concentration of Pb not the same as calculated one when testing using AAS?

I am currently doing research on the adsorption of heavy metal using magnetic reduce graphene oxide. I use AAS to determine the concentration of the heavy metal. I prepare the Pb solution with...

26 February 2021 9,580 4 View

Is this the write procedure for acid digestion of soil for heavy metal analysis using AAS?

How to do acid digestion of soil sample with 3:1 aquaregia in an open vessel?

23 February 2021 3,053 7 View

Thermal reduction of graphene oxide.?

I am trying to reduce graphene oxide by thermally but I have no proper information regarding this. Can any one help me regarding the details about temperature and time for the reduction of...

23 February 2021 4,155 4 View

Is there an ideal incubation time of RGO-modified SPCE before subsequent use, i.e., electrochemical characterization or further modification?

I notice that upon washing and air-drying of my RGO/SPCE surface and characterizing again via DPV, the current response towards ferricyanide probe significantly decreases. My worry is that the...

22 February 2021 5,324 3 View

How can I simulate the optical absorption spectrum of a biomaterial (like DNA or protein) in COMSOL?

I need to simulate the optical properties of a biomaterial, namely DNA, in COMSOL. Basically I need to simulate the IR absorption spectrum of a cylinder filled with a 'concentration' of DNA. I am...

21 February 2021 3,043 3 View

What is the best substrate for exfoliating few layers of hexagonal boron nitride (hBN) using traditional scotch tape method?

Unlike graphene, it is usually very difficult to exfoliate few layers (~10 nm thick) of hBN on SiO2 substrate due to lip-lip interaction at the edges. Au substrates have been proven very useful...

16 February 2021 2,635 2 View

Unusually Busy Raman Background?

Hello, I am observing a nearly periodic background spectrum for a wide variety of SERS substrates. I see this response (attached below) for bare Au films, Cu films, and Au nanoparticles on...

15 February 2021 9,922 5 View

How to determine the drug loading and the drug release capacity of a polymer micelle using UV spectroscopy?

Currently, I am working on PLA-PEG copolymer micelle for the drug delivery system. I have seen several papers where some researcher talks to centrifuge the drug-loaded micelle to separate the...

13 February 2021 5,822 7 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close