will the antibody binding be affected? (recommended is 0,02-0,05%)
i would be happy to get some help
0.1% is a perfect concentration for the purpose. Lower concentrations might be preferred mainly due to the high toxicity of sodium azide.
Hello! I need to simulate and investigate possible chemical interactions between some polymers and dye molecules. Is there any free reliable software you would recommend? Thank you in advance....
29 January 2021 541 2 View
Dear all, I am planning to undertake quantitative research with a survey for my thesis. I am wondering if the hypothesis formulation is compulsory or am I able to do my research without it? My...
29 July 2020 6,145 5 View
hello, i need some help. i am searching for good reference values for pediatric laboratories for the potassium levels. in the newest version of "Thomas" i found a good table, but they did not...
05 February 2020 3,396 6 View
Just briefly: I have WB quantifications from 4 different blots (4 biological repilcates) and I normalized my signal intensity values to the untreated ctrl sample. Therefore, for all 4 replicates...
14 July 2019 3,258 3 View
This might seem like a rather simple problem, but I am actually unable to find a helpful solution that specifically refers to this problem. I did several Western Blots of biological replicates...
10 July 2019 6,476 5 View
We are currently looking for cheaper alternatives for removing detergent from proteins during reconstitution into membranes. Bio-Beads work nicely for us, but they are costly. We found now...
15 May 2018 559 2 View
Thankful for any help!
24 April 2018 3,291 8 View
To enumerate the total amount of bacteria per blood volume, I would like to selectively remove host cells from mouse blood while retaining bacteria. Size filtration is unlikely to work as filters...
22 October 2017 6,278 3 View
Is there any study around on how well bacterial transcriptomes are preserved when they are taken out of the "in vivo" situation and kept on ice for varying amounts of time? In other words, how...
12 September 2017 2,450 2 View
If not, how can I access the English version? I would like to use it for my Master's Thesis. Thank you!
18 October 2016 1,283 1 View
Hi all, I am validating a polyclonal antibody raised against human ANT4, through WB and ICC. In most of my controls, the antibody shows very little off-target binding, but when I pre-incubate the...
03 March 2021 5,999 3 View
The term miscibility refers to the single-phase state in thermodynamics. I do not mean the compatibility of different components. To determine the miscibility I know several techniques such as...
03 March 2021 4,107 4 View
Santa Cruz now recommends this new antibody (F-10) but I can't find a publication using this reference. I'm working on human et non human primate hypothalamus and so far, it doesn't work. Is...
02 March 2021 10,003 2 View
Hello Everyone. Currently I am working to characterize macrophages in the myocardium after ischemia-reperfusion injury in rats. Due to the low total cell number isolated from rat hearts I can...
01 March 2021 3,867 3 View
We have been using Thermo Fisher anti-cardiac Troponin T antibody for immunofluorescence staining in FFPE mouse heart sections but it was recently discontinued. The literature shows it to be the...
01 March 2021 4,937 1 View
I am looking at the ATP1A2 (Sodium/Potassium ATPase alpha subunit 2) in two human neuronal cell lines. Expression levels of this protein seems to be almost equal when detected by one antibody....
01 March 2021 3,607 3 View
Hi, I am running a size exclusion chromatography experiment with a buffer containing Potassium Acetate as a salt. I analyse these fractions through SDS-PAGE. After boiling my SEC fractions in...
01 March 2021 2,622 3 View
Hello, I was just wondering how does a antibody have full intact antibody + half antibody? Is it because of the drug conjugation?
28 February 2021 1,577 1 View
I am looking for anti-nuclear antibody (ANA) and anti-Phospholipid antibody ELISA kit for Non Human Primate serum samples. Any suggestions highly appreciated. Thank you.
28 February 2021 6,512 3 View
When you use RIA, with a control the unknown sample with antibodies, you bare in mind the binding sites of the antibodies. However you still need to measure labelled antigen (radioactive) and not...
28 February 2021 2,133 3 View