Experimental data was obtained from UV-vis and Fluorimetry techniques?

More John Mathaga's questions See All

Band gap and emission? Excited state 1: Singlet-A 3.1234 eV 396.95nm f=0.0349 <s**2>=0.000, what does the 3.1234 eV represent in this result?

I am getting the following result from gaussian calculation in the determination of emission spectrum of an organic compound. Excited state 1: Singlet-A 3.1234 eV 396.95nm f=0.0349...

10 November 2016 9,028 3 View

Fluorescence emission maxima?

How off should be the emission max calculated from gaussian be? I am getting an emission max of 368 nm while the experimental is 400 nm for a compound. What can I do to improve my results? I am...

10 November 2016 7,938 0 View

Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

Any research papers for extraction of nutrient deprivation on macroalgae? Analysed by HPLC-UV and GC/MS. Possibly from macroalgae genus Rhizoclonium?

I am doing my thesis on the nutrient deprivation on the macroalgae Rhizoclonium sp. I will be analysing the levels over a period of roughly 5 days by HPLC-UV and GC/MS. I will be using seawater as...

28 February 2021 6,477 1 View

Why initial concentration of Pb not the same as calculated one when testing using AAS?

I am currently doing research on the adsorption of heavy metal using magnetic reduce graphene oxide. I use AAS to determine the concentration of the heavy metal. I prepare the Pb solution with...

26 February 2021 9,580 4 View

Is this the write procedure for acid digestion of soil for heavy metal analysis using AAS?

How to do acid digestion of soil sample with 3:1 aquaregia in an open vessel?

23 February 2021 3,053 7 View

How can I simulate the optical absorption spectrum of a biomaterial (like DNA or protein) in COMSOL?

I need to simulate the optical properties of a biomaterial, namely DNA, in COMSOL. Basically I need to simulate the IR absorption spectrum of a cylinder filled with a 'concentration' of DNA. I am...

21 February 2021 3,043 3 View

In methylene blue test Why is UV absorbance reading very low as soon adsorbent is added and then increasing before reaching equilibrium?

Hello, I'm working on removal of methylene blue. 01. in the dark test very first reading is taken 15 minutes after adding adsorbent to the dye solution and that UV absorbance reading is very...

19 February 2021 472 5 View

Which detection method is better for an ELISA-based assay: colorimetric or fluorometric?

Hello, I am planning to perform an ELISA-based assay to quantify the percentage of genomic methylation (5-methylcytosine) in human embryonic stem cells. I've been searching for some kits and I...

16 February 2021 8,389 3 View

Unusually Busy Raman Background?

Hello, I am observing a nearly periodic background spectrum for a wide variety of SERS substrates. I see this response (attached below) for bare Au films, Cu films, and Au nanoparticles on...

15 February 2021 9,922 5 View

How to determine the drug loading and the drug release capacity of a polymer micelle using UV spectroscopy?

Currently, I am working on PLA-PEG copolymer micelle for the drug delivery system. I have seen several papers where some researcher talks to centrifuge the drug-loaded micelle to separate the...

13 February 2021 5,822 7 View

What is the UV-vis spectroscopy and HPLC UV detector?

I did spectrum scan to levothyroxine sodium which show highest absorption at wave length=230nm which the absorption =0.136 and it's absorption at 225nm =0.047 but when Injecting it on HPLC...

09 February 2021 1,631 3 View