Dear Friends
I am trying to use a new mesh in a case and use last data and continue my run.
All hydrodynamic variables (velocity,K,eps ,P) will be done but mass fractions couldn't be interpolated.
fluent error said unable to read ### bytes. variable couldnt be found while I can see contours and reports.
I should mention that I use a compiled UDF and Although libudf has been removed, reaction seems to be solved truley.
regards
Dear Daniel
thanks for your attention.
yes I am studying a multiphase flow in which 4 reaction in series occur.
Now I want to change my mesh because of its low quality and continue running solution. In interpolation all hydrodynamic and phase fractions are truly interpolated But in interpolating concentrations I confront with that error.
Best regards
@ Dear Alexander
It has written for reactions, A-> B->C->D->E
Do you think obliteration of Libudf from folder causes this error?because results are logical without it
Dear Daniel
From your point of view it seems to be an problem which is originated from governing equations but I thought it is from software problem while I can see contours of species.
I use a gas-liq multiphase with and Eulerian approach and no discrete phase is assumed.
and yes! mesh quality is poor but think about it that why I have run 90 seconds of flow time and this mesh can cause to show contours and even can interpolate hydrodynamic and volume fractions.
let me generalize question, error in interpolating some variables can be dependant to mesh and equations while I have ran problem for lots of iterations?
- Badges
- Science topic