If anyone uses the XRS-FP software for XRF analysis I would appreciate if he could tell me some comments ..If he/she. is satisfied from the use of this software and approximately how much time it takes to be someone familiar with it
I use this software during my PhD so if you use it everyday you can become familiar in few months. It is a good software but the need of different standard materials can complicate the use. In my routine analysis I use FP-Method with calibration of TCC on standard with similar composition to analyzed samples. Sometime the problem is the repeatability of measurements because each slight modifications can vary the count rate. The crucial point in the software settings are the geometrical parameters: distance and angle between detector and X-Ray tube from the sample surface.