Hi All. I want to mesh the geometry below with ansys mesher,first i tried to mesh the helical pipe I put mapped face on cross section(inner pipe) with 2 division ,when cheking meshing i found i farther cross section an non-uniform mesh as shown in picture.how to fix this issue and how to make a uniform mesh an all cross section of the geometry;
This is a great question and a very interesting topic from a computational topology perspective.
A helpful discussion concerning the Ansys mesher is available at
https://www.researchgate.net/post/create_more_cell_zone_conditions_in_ansys
and
https://www.researchgate.net/post/How_to_import_correct_model_for_ANSYS_FLUENT
and in
https://www.researchgate.net/post/How_to_solve_non-positive_volume_cells_mesh_issue_in_icepak
A thorough-going study of the usage of Ansys mesher is given in
Chapter CPU Heat Sink Cooled by Nanofluids and Water: Experimental a...
A practical application is given in
Conference Paper Analyzing of two types water cooling electric motors using c...
- Badges
- Science topic
- Similar topics
- Force