HI all;

I am using Ansys 16 fluent .in order to have node to node mesh i used a conformal mesh by modifying multiparts multibodies to one part multibodies when exporting the mesh file to fluent i didn't find the item to set interfaces(coupled wall in my case).

my question is how is it possible to set coupled wall in conformal mesh?

or it's not necessary to set coupled wall in conformall mesh?

if i run calculation without specifying coupled wall would it affect the pretended result?

second part of my question

for the same geometry i performed non conformal mesh by keeping multi-parts multi-body ,the result of mesh is no node to node mesh it look like bad meshing but it offers the possibility to set interfaces(coupled wall) when updating to fluent ;

Does this case (no node to node) give a good results after running calculation?

More Mostefa Aichouba's questions See All
Similar questions and discussions