Does anyone have a good method for extracting polymer from explanted polymer implants with substantial tissue ingrowth? The polymer can not be physically separated from the tissue, ideally the method would be chemical extraction. Specifically the polymer is poly(lactic acid) or polylactide. I have paraffin blocks of tissue that have been used for histology of the constructs, but I would love to be able to run GPC on the polymer remaining in the block samples. If anyone has any advice please let me know, I am curious how much polymer I will need to extract. Thanks!
I think this question is most relevant for tissue engineering, bioengineering, regenerative medicine, and looking at biodegradable implants in vivo. Tissue could be human or animal.
For GPC measurements you will need a solution of PLA, so you could use an organic solvent that dissolves the polymer and does not dissolve the rest of the materials that are present in your sample. Maybe DMSO? Just a thought.
Hexan is a good solvent for paraffin, but is a no-solvent for PLLA.
Try to remove the paraffin and then dissolve the polymer in methylen chloride or THF.
I think, that you can use the procedure of tissue removing given in this paper: Lam et al., Evaluation of polycaprolactone scaffold degradation for 6 months in vitro and in vivo. J. Biomed. Mater. Res., (2009) 90A: 906–919.
Regarding to minimal amount of polymer, it depends on used GPC system and measurements parameters. In our lab we need at least 0.5-1ml solution of PLA or other polymer in solvent, (ie THF, CHCl3) with concentration 1-2mg/ml.
Hi Kevin,
I think you should try to dissolve the polymer in the appropiate solvent (such as chlorofrom), and check whether you do not destroy the remaining tissue.
Let me know if this help.
- Badges
- Science method
- Similar topics
- Chemistry
- General Biochemistry
- Biochemical Techniques
- Analytical Chemistry