Does analysis in Ansys and Hyperworks give same result for a specific analysis carried out in both?

More Nittala Sai Krishna Teja's questions See All

Which Material has good torsional rigidity among the following?

Among these materials which has good torsional rigidity? 1. Stainless Steel. 2.Aluminium. 3. Copper. 4.Iron.

09 October 2016 2,766 3 View

Are there any scopus indexed journals which can give the review report within 2-3 months?

Do we have any engineering journals which can give the review report within a couple of months like 2-3 months?

06 July 2016 2,054 14 View

Is there any benefit in joining as a reviewer in any journal?

If yes ? Will he get paid for reviewing a paper or not ? And if he is not paid what can be the other benefits in joining as a reviewer?

05 June 2016 3,189 8 View

If we draw a part in the newer version of design software, we cant open them in the older version. Is there any remedy for that?

is there any chance that we can open that in the older version also

05 June 2016 1,852 3 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

Resistor definition in Piezoelectric bimorph with ANSYS workbench

Hello, good day! I am trying to simulate similar bimorph piezoelectric harvester with below commands. However, the output power doesn't change with resistor value. Please help to find the reason. ET,10,CIRCU94,0 !SET UP RESISTOR R,1,100000 !RESISTANCE VALUE TYPE,10 !SET ELEMENT TYPE E,1,2 !CREATE RESISTOR BETWEEN NODES 1 AND 2 Thanks in advance Regards,

02 March 2021 0 0 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

What is the characteristic length to determine the Reynolds number for the scattered turbulent fluid flow?

Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...

02 March 2021 1,999 5 View

LOAD DISPLACEMENT CURVES Stiffness increasing in ANSYS non linear analysis. HOW CAN I CORRECT IT?

Hi. I am doing non linear FE analysis using a new material beam under flexural 2 point loading using ANSYS. I have defined a bilinear material model. The solution has converged. In results I am...

01 March 2021 9,911 3 View

Tiruvidula ESWARA Rao

must give same results if the inputs and formulation are same.But by using more elements and and increasing mesh size better results may be possible with Hyper mesh.

Pankaj Biswas

Yes, both analysis are numerical FE method so both should give same results, if the model, mesh, boundary conditions, inputs and all other criteria are same.