Do you have experience working with interfaces between TiO2 and Copper oxides?

09 September 2013 0 2K Report

I'm looking for accurate data, theoretical and/or experimental, about bandgap alignment in TiO2-Cu2O heterojunctions, for the three TiO2 phases.

Badges
Science topic

More Ariel Cedola's questions See All

Can flexible substrates be used to grow films in magnetron sputtering systems?

I want to grow thin films (e.g. TiO2) on flexible materials. Which substrates could be used? It should support high temperatures. I guess that the adhesion of the sputtered target is an issue, right?

05 June 2014 10,005 10 View

Is it possible to obtain good InAs/GaAs heterostructures by magnetron sputtering?

The aim is to grow quantum wells for experimentation by this technique. Could be based on other materials if III-V are not suitable.

10 November 2013 9,637 7 View

What does it mean that the semiconductor equations are strongly coupled, preventing the Gummel method to reach the convergence?

Gummel method is hard to converge when the coupling between semiconductor equations (Poisson, continuity of electrons and holes) is strong. In this situation, Newton method is the appropriate...

09 October 2013 1,127 13 View

Literature on band gap engineering?

Can you suggest authors and titles? I'm reading that great book from Prof. Capasso.

08 September 2013 7,232 1 View

What is the procedure to determine the dopant density of a semiconductor, by using EDX technique?

To know the average donor concentration of an n-GaAs or n-Si layer.

08 September 2013 4,802 7 View

Which type of compound does lamda max of 218 indicate in a uv-vis spectrum of a partially purified compound through column and TLC?

A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...

11 August 2024 9,801 2 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

What is the best conditions for formation Magnetite ore deposits?

I want to know more about Magnetite deposits.

06 August 2024 1,066 0 View

How can I measure the thickness of thin film by Uv-Vis?

06 August 2024 7,810 3 View

Why is TLC not a form of partition chromatography?

Why is TLC not a form of partition chromatography and paper chromatography not a form of absorption chromatography?

03 August 2024 7,035 3 View

Short Synthesis of Graphene Oxide from Natural Graphite Flakes?

I am in search of a modified Hummer's method, which can be used to synthesis graphene oxide within 6-8 hours. As I am a student it is not allowed for us to work after 5 in the laboratory. So I am...

01 August 2024 8,368 2 View

Is there a good freeware software for photodocumentation of TLC?

I need something like Camag's VisionCat software for photodocumentation of TLCs. Could you recommend something?

31 July 2024 8,415 1 View

¿Are oxygen vacancies in semiconductors capable to change the band gap?

Dear all! Oxygen vacancies do raise negatively the Fermi level by increasing the negative charge in the semiconductor crystal structure. In the case of n-type semiconductors, I wonder if this...

30 July 2024 8,339 2 View

How to build my own lab made four point probe set up?

Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...

30 July 2024 906 2 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View