Difference between the Coupled channel code CCFULL and FRESCO; which is better?

03 October 2023 0 6K Report

Badges
Science topic

Similar topics
Phytochemistry
Extracts

More Rayees Yatoo's questions See All

Requirement of server specifications for faster calculations of nuclear fortran code FRESCO?

What will be the requirements for the device to fasten the calculations in the coupled channel nuclear code FRESCO. Kindly provide the specifications like RAM, other memory requirements and...

18 December 2023 8,167 0 View

How to Check Endogenity in AMOS?

How do I check the Endogenity in AMOS if i have one IV (Knowledge sharing) and one DV (Performance). And how do I check the robustness if I have Knowledge sharing as IV and Performance as DV and...

20 May 2022 9,643 1 View

What are are new psychological tests used now a days for assessing intelligence ?

intelligence is important concept.

29 March 2022 9,073 5 View

How to calculate the velocity of the glaciers through Sentinel imagery?

Sentinel imagery is widely used for the estimation of glacier velocity according to the literature.

16 June 2021 5,265 4 View

Which method can be used to measure the temperature of a water body through remote sensing and which satellite data?

waiting for your reply

09 May 2021 7,036 32 View

Which one is a better journal metric CiteScore or Impact Factor?

CiteScore calculation is based on Scopus data, while Impact Factor is based on Web of Science data. For example, Journal of Intellectual Capital has a CiteScore of 8.6 and an Impact Factor of...

01 July 2020 5,725 6 View

Reason why my Plasmids isolated using alkaline lysis didn't dissolve in water?

Hi everyone I isolated some plasmids, using alkaline lysis method (which I have been following for 2-3 years now) and the final plasmid pellet after washing in 70% ethanol was dried. Then I added...

23 December 2018 6,972 2 View

What is the best method for LST mapping using landsat satellite data? And which month would be better to choose if we are using last 30 years data?

Need good suggestions.

05 September 2018 5,466 11 View

Hi dear actually the same project you choosen, I also work on it and my prototype is read?

My idea Energy hearvesting from rf especially (GSM) topology is ready to implement so I need sponsorship for the same so please. Thanks

15 January 2018 5,232 1 View

Can we compare the nested and non-nested models based on model fit indices viz. GFI, AGFI, CFI, RMSEA and RMR

And how can we differentiate between nested and non-nested model in SEM. Can we select the model based on AIC and BIC.

27 May 2017 9,820 1 View

Is the mentioned CV graph a valid one as this graph have only one peak prominent (reduction)?

I have used Prussian blue nanoparticles as a redox couple. The PBNPs have been made using only one salt precursor. Also, during scan rate studies, a small oxidation peak can be consistently found...

31 July 2024 9,697 0 View

How to draw photon-magnon coupling color plot in origin?

Please help me in plotting the photon-magnon coupling plot as shown below

14 July 2024 1,632 1 View

How to solve the question of ansys fluent?

Regarding the system coupling issue where the update of the solution component fails, the system coupling update for fluid flow (Fluent) triggered an exception: "Update Solution Failed."

30 June 2024 7,894 1 View

Does anyone have suggestions for this esterification?

I have a very polar alcohol (soluble in MeOH, H2O, partially in heated DMSO). And a long chain fatty acid that I would like to couple. I can't find a common solvent for them. I can form the...

24 June 2024 9,319 0 View

How to verify the correctness of an abaqus model and how to make a thermally coupled model converge to the correct values?

Hi all, I am doing a hot rolled composite simulation, but the same model, using the implicit and explicit algorithms gives the results shown below, why do the two algorithms give completely...

14 June 2024 7,737 1 View

How to FE model from Modal analysis to use in Static Structural in Ansys?

I have two components for which I want to extract some number of modes shapes for each. Then using those model of the component I want to couple them together for non linear static analysis.

10 June 2024 1,234 0 View

How do couples enjoy adventurous sex play?

Most couples who rate their sex lives highly say they are proactive in sex. They think about when, where and how they’ll have it and think up new things to try. (Tracey Cox)

05 June 2024 6,504 5 View

How can sex therapists ignore the concept of sexual consent?

Men want more sex than they usually get. … It’s no wonder, then, that couples argue most often about sexual frequency… (Kramer & Dunaway)

02 June 2024 1,238 2 View

Is it easier to couple polypeptides after a few days of dissolving them in PBS?

I want to couple the polypeptide to a cell culture plate, is it easier to couple the polypeptide after a few days of dissolution in PBS?

21 May 2024 9,684 1 View

For immunofluorescence of mouse embryos, is there a best way to store semi-long term?

I'm on a time crunch and have to fly back home and my return date to the lab where I'm doing my research is yet to be determined (hopefully in the next couple of months). I'm hoping I can store at...

15 May 2024 2,572 0 View