Does the pressure(-600 mmHg) affects pH?

When I conducted the degassing experiment using decompression under anaerobic condition(and I used ferrous based chelating agent), the oxidized ferric were observerd. So, could you tell me the...

03 March 2021 4,892 5 View

How can we raise the figure when we writing a paper with Latex ?

Hi, everyone. I'm a starter to write a paper by Latex. But I have some difficulty using it. I'm writing the paper with 2 columns. And, there is one figure that occupies the 2 both-sides. I want to...

26 February 2021 3,738 3 View

Satellite orbit estimation using Recurrent Neural Network - what should I use?

Hello, I am a master's student studying in Yonsei Univeristy, Korea. I am trying to estimate the state of satellite, using Neural Network. Below is a simple flow of my study. 1. Train (t0 ~ t1)...

23 February 2021 6,383 3 View

What is the system of units used in the thermal conductivity by Spitzer and Harm?

23 February 2021 9,253 1 View

How many days do we need to detect adoptively transferred Treg in the tumor site in tumor-bearing recipient mice?

Hello, I've got a plan to isolate mouse splenic Treg (WT and KO of target gene) and inject these CD45.2 Treg into tumor-bearing CD45.1 mice. My question is how many days do I need to wait to see...

11 February 2021 8,238 1 View

Is it possible to antibody labeling with FITC cause antibody disfuction?

Hello, I studied how much bound my test antibodies to the target antigen using FITC labeling to test antibodies. I tested 3 types of antibodies, the elisa binding affinity and cytotoxicity...

07 February 2021 8,335 2 View

Does anyone knows about a comercial software to record pressure and temperature during reaction in an Autoclave?

Dear all: Currently I am working with polymerization reaction in a reactor. For this, I need to control temperature, pressure, agitation speed etc. For calculation of rate of polymerization, I...

07 February 2021 355 2 View

Can you use MTS assay with cells cultured in media containing phenol red?

I am trying to run a cell viability assay with LN229, but these cells are cultured in DMEM which contain phenol red. Is the MTS assay sensitive to the additional of phenol red in the media? If so,...

03 February 2021 9,478 2 View

How to obtain the plot of frequency shift w.r.t. pressure in a micro resonator (cc beam) based MEMS pressure sensor in COMSOL?

I need to know how to plot the impact of pressure (0 - 100 kPa) (which is applied on the back side of diaphragm) on the frequency shift caused in the cc beam supported on the diaphragm with...

01 February 2021 5,805 17 View

Lighting for open field test behavior assay?

I am currently setting up our lab's behavioral space to run the open field test in rats, and I am trying to figure out how to set up lighting to evenly illuminate the open field chamber (a 90 cm x...

26 January 2021 1,399 3 View

How to find the mean, SD and CI in SPSS?

Hi, I hope that someone can help me with this task: I have 5 groups of participants which are numbered in SPSS from 1 to 5 (according to their group number) and are all under the variable group....

03 March 2021 506 3 View

Waters 2707 HPLC autosampler problem?

I am using a 2707 waters HPLC device. When I try to inject a sample, it says missing plate or rack. I changed the needle and calibrated its position but I still get the same problem. I even get...

02 March 2021 1,408 1 View

Can you share me how teacher education is managed in your respective national educational system?

I feel that the practice in teacher education in my country is below the expected performance level due to very poor management system. Hope I will learn something from your experiences.

02 March 2021 1,516 4 View

What is a good reagent for lentiviral plasmid transfection in HeLa cells?

I have been using Lipofectamine 2000 but was hoping there may be a better protocol or one for something like Lipofectamine PLUS reagent.

24 February 2021 1,633 4 View

Which type of loading is to be used in dynamic analysis of Machien foundation?

Hello Everyone, Hope you all are doing well. I'm trying to simulate a machine foundation in ABAQUS with a geo-cell reinforced soil bed. Im totally confused to which type of loading would be...

21 February 2021 4,388 3 View

Drop weight impact testing machine for composites?

Dear all, I hope everyone is safe and healthy I do have a question please. Where can I find a drop-weight impact testing machine to test fiber reinforced polymer composite plates (CFRP and GFRP)...

17 February 2021 3,820 3 View

RDF calculation of water inside the Carbon nanotubes?

I am trying to calculate the rdf of water molecules present inside the Carbon nanotube. I tried to do the indexing first using gromacs tool gmx selection. But when it comes to calculating rdf, I...

17 February 2021 1,066 3 View

What can I do to keep magnetic beads suspended in solution within a syringe?

I'm looking for ways to prevent the settling of magnetic beads in solution. I have been using a syringe pump to inject a suspension of magnetic beads in PBS into a microfluidic device, and so far...

09 February 2021 6,206 2 View

Soil DNA extraction kit recommendations?

I was hoping someone might be able to give me some recommendations for soil DNA extractions kits which they've had success with recently. I've been using Zymo miniprep kits for the last year but...

03 February 2021 4,322 1 View

I need help with adsorption kinetics. Basically non-linear plots of pseudo first, second order, avrami equation, elovich and intra particle diffusion?

The questions are too twisted to be explained here. I was hoping if someone who has published a paper can guide me for the same. Kindly contact me at [email protected]. I'd be grateful.

01 February 2021 6,886 2 View