11 September 2017 2 372 Report

Dear CFD researchers,

I am trying to learn different physical flow and thermal problems using openFOAM. Right now I am trying to run a simple conjugate heat transfer problem for a simple pipe geom. I have done the setup by looking into various theories and steps I got from the internet and the simulation runs for around 180 iters and then diverges. I know, I have made some error in the way problem is set. I am using mapped wall feature to connect the fluid and solid domains for physics transfer. 

I need help from people who have experience working in openFOAM. I would like to know if there is any other method which I can employ to get this done.

[PS: I am importing the mesh from ANSYS Meshing and not using blockMesh]

Thanks in advance!!!

Dhyan Shankar

More Dhyan Shankar's questions See All
Similar questions and discussions