Can we comment on the defects of a material based on PL quenching?

17 July 2020 0 5K Report

The steady state PL of a film prepared in different conditions showed difference in PL peak intensities. How can we correlate the defects of the material based on this difference? If TRPL is a better alternative, how to extract the data from TRPL measurements?

Badges
Science topic

Similar topics
Comment

More Ramya Krishna Battula's questions See All

How can i start study on warm whole theory?

To study the warm whole theory, what is the roots of the this theory and where can i start and which books will i prefer.

26 April 2024 2,788 2 View

Why do sometimes O-H peak of carboxylic acid disappear in NMR spectrum?

Reason for the disappearance of O-H peak in NMR

24 April 2024 5,816 5 View

In fluorescent chemosensor, why the designing of the prob is getting difficult in different solvent environments?

24 April 2024 2,812 1 View

How can i find my papers (which are added in research gate) in google scholar??

I have added all my research paper in research gate.. but i could not FIND these papers IN google scholar.. Help to resolve this problem.

17 April 2024 4,982 2 View

What is the recent developments in microbial fuel cell ?

In microbial fuel cell Which type of electrodes and membranes can be used and what is the material (waste) is taken.

12 February 2024 5,956 1 View

Which passage number of primary HFF-1 cells could be bad for HCMV infection?

I have been trying to infect primary HFF-1 cells with Human Cytomegalovirus WT. Most of teh times the infection itself works. SOme of teh attempts, the cells looked very stressed after...

31 January 2024 2,704 0 View

WHat could be the reasons for observing no interaction in another cell line?

An interaction between my viral protein of interest and a host protein is observed in HEK 293T cells but not in HFF1 cells.

28 January 2024 7,094 1 View

How much water is required to make a adobe brick?

I am going to do research in fiber reinforced adobe bricks

21 September 2023 6,328 0 View

Detection of IL-1B in activated BV2 cells by LPS+Nigericin?

Hello, I am trying to show production of IL-1B in BV2 cells activated by LPS+Nigericin. Tried seeding all the ranges from 2*10^4 - 10*10^4 cells per well in a 96WP. Treated with LPS (1ug, 2ug,...

13 September 2023 2,481 2 View

I am unable to get proper yield of DNA after purification using Qiagen kit is there any suggestions?

Qiagen PCR purification kit is the DNA purification kit., after following the manufacturers protocol I am unable to get the yield.

28 August 2023 5,987 3 View

Strugglling with m6A dot blot any suugesstion ?

I have been doing the m6A dot blot for a while with no improvement, I am extracting the RNA, and I can see the dots although the three biological replicas give a different reading on the memberan...

10 August 2024 8,539 5 View

How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?

09 August 2024 7,718 0 View

What procedure should I follow for current controlled PPy film electrochemical deposition on ITO?

For example, I perform passivation process before electropolymerization of Py for adhesion to titanium surface. Is a similar or different procedure required for ITO? If necessary, I would be glad...

06 August 2024 3,176 0 View

The aqueous fraction of the hydroethanolic extract is showing the presence of palmitic acid. What is the mechanism responsible ?

Palmitic acid presence in aqueous fraction

05 August 2024 8,624 4 View

Which solvent is better to dissolve with secondary metabolites extracted from fungi?

I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...

03 August 2024 4,725 2 View

Comment ajouter une recherche ?

En suivant toutes les étapes mentionnées sur (ajouter une recherche) il me signale erreur, ressayer, j'ai essayé plusieurs fois, sans succès, toujours il me signal erreur, ressayer

02 August 2024 9,719 1 View

For systematic review data extraction, should I use ITT or PP analysis, and count all randomized participants or only those who completed the study?

I am conducting a systematic review and meta analysis; as I am extracting data I realized there is a consort diagram that shows the number of patients from randomization till end of the study. So...

01 August 2024 9,993 3 View

For the moringa oleifera extract using ethanol as the solvent,what is the alternative method to concentrate the extract other than rotary evaporation?

99% pure ethanol was used for maceration also alternate methods along with the temperature and time to concentrate the extract can be specified

31 July 2024 5,113 4 View

What are the factors that causes the sample to have higher efficacy at lower concentration?

We conducted an antibacterial study of a plant extract. Varying concentrations of crude extract were subjected to microbroth dilution assay. The result showed that only the lowest concentration of...

31 July 2024 8,666 3 View

What Are the Best Alternatives to the MTT Assay for Assessing Cell Toxicity of Colored Herbal Extracts?

I am currently investigating the cytotoxicity of a series of herbal extracts, and like many studies, I have been using the MTT assay to evaluate cell viability. However, I am encountering a...

31 July 2024 193 4 View