Can I use Study 1 and Study 2 with the same results?

25 December 2023 0 3K Report

I got the same results from two samples from two different countries (China and USA). I tested my theoretical models (one mediator, and one moderator) and found that all hypotheses were supported using two samples. So, I don't know how to structure my paper. Can I use "Study 1" for China sample and "Study 2" for USA sample in my paper? How can I structure my paper?

Badges
Science topic

More Kiho Jun's questions See All

How to remove the residual PDMS on the silicon mold?

Incompletely cross-linked pdms are difficult to remove.

01 March 2021 798 3 View

How to remove the species data from rda data frame in R (only remain the sites/samples point)?

Dear everyone, When I using the rda function in r, I met this question. As you can see in the figure, there are a lot of deep blue points which refers to the species. But I would like remain...

15 February 2021 8,982 2 View

How to simulate enzymatic hydrolyis of sucrose in a CSTR coupled with ultrafiltration membrane with comsol?

Dear all, I am trying to simulate the enzymatic hydrolysis of sucrose with invertase in CSTR in Comsol. The reaction pathway is such that Sucrose + Water -> Fructose + Glucose. It is desired...

27 January 2021 2,525 4 View

How to design an Ultrafiltration membrane for a CSTR?

Dear all, I am designing an Ultrafiltration (UF) membrane coupled with a CSTR. It is desired to utilized a dead end stirred reactor. The main purpose is to separate the enzyme used from the final...

27 January 2021 7,924 1 View

What is the significance of Per-Patient and Per-Tooth analysis in epidemiology?

Research in prevalence usually provide results in per-tooth/object level and per-patient level. What is the significance of these two values and which is actually more important/accurate? What are...

10 December 2020 4,248 4 View

For SIADH, does it cause edema and Hypertension?

I have found two teachings from different sources. One they said about blood volume increase and therefore the patient has oedema and hypertension. But, another source says when there is high...

08 December 2020 1,278 3 View

What are the possible causes of cloudy mouse retinal lysate?

Hi, We are studying the retina in a knockout mouse model. Compared with the control wild-type retinal lysate, the knockout mouse retinal lysate often looks cloudy. We lyze the mouse retinas in...

04 December 2020 8,720 3 View

Why are all the cells are stained by EdU when performing EdU assay?

I was wondering whether there is anyone else have this problem? As shown in the images, almost all the cells are stained with EdU, some are whole nuclei (circle 1), some are puncta inside (circle...

02 December 2020 6,911 4 View

Write a self-appreciation of and reflecting your own unique understanding of the research process based on the said Figure ?

Figure may prove not really very hard to understand and appreciate what it means.

15 October 2020 8,245 1 View

What aspect of the experience would you think should be a subject of educational research that feed into the planning of the future of education?

You have seen how educational survey research can give us a view of reality in the life of an educational system that feeds educational planners and leadership as well as curriculum planners...

14 October 2020 2,874 8 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

I got 02 moderator values defining Johnson-Neyman significance regions. Is it an error?

Hi everyone, I am conducting research for my Master's thesis. I am using PROCESS by Johnson-Neyman to analyze my Moderator model. I test the relationship between Public Service Motivation and...

03 March 2021 2,350 2 View

How to repeat an operation on an atom selection for multiple times in PyMol?

Hi, I am trying to construct a multi-layer fibril structure from a single layer in PyMol by translating the layer along the fibril axis. For now, I am able to use the Translate command in PyMol...

02 March 2021 4,569 4 View

What analysis to choose with a large neste dataset and clearly skewed or kurtotic distributions?

Hello! I have a dataset of n=3000 nested within 8 countries with approximately 200 or 400 responses in each country. I originally planned to perform multilevel modelling with 4 dependent variables...

02 March 2021 6,865 1 View

Is there any published or unpublished statistics on dropout rate (Dose1 to Dose-2) for Covid-19 vaccination in India, US, UK or any other country?

Are there any published or unpublished statistics or papers on the dropout rate (Dose1 to Dose-2) for Covid-19 vaccination in India, USA, UK, or any other country where vaccination has started at...

28 February 2021 4,237 1 View