I am simulating the motion of the lung as a function of time providing my model with the BC displacement. these displacements are provided in a FORTRAN subroutine, I believe it will be much easier for the system to analyze everything without using the abaqus interface, and in the manual, it is explained how to run the simulation from the command line: https://help.3ds.com/2019/English/DSSIMULIA_Established/SIMACAEEXCRefMap/simaexc-c-analysisproc.htm?ContextScope=all&id=f57d973133414d108bde5daca8e0a127
but I couldn't figure out how to link my FORTRAN code to it. Is it doable?
Thank you so much for your help in advance.
This is relatively easy, you can refer to the help manual in ABAQUS DLOAD subroutine, I believe it can help you solve the related problems.
This is relatively easy, you can refer to the help manual in ABAQUS DLOAD subroutine, I believe it can help you solve the related problems.
This is relatively easy, you can refer to the help manual in ABAQUS DLOAD subroutine, I believe it can help you solve the related problems.
Hi,
Not sure if you still need this but in case anyone else might. Simply put in the following command: Abaqus job= user= interactive. (I believe you don't need the file extensions) Be sure to navigate to the correct directory and have both your .inp file and your .f file ready in the said directory. Obviously, the FORTRAN compiler needs to be properly linked to Abaqus as well.
- Badges
- Science topic
- Similar topics
- Biological Science
- Physiology
- Physiological Processes
- Stress