Conversion of Crystalline to amorphous carbon?

Hi, Can anyone help me suggest some papers or books to understand more about conversion of crystalline carbon to amorphous carbon? What are the different methods and reasons that can facilitate...

06 July 2018 4,268 3 View

Can we distinguish multilayer graphene with bulk graphite flake? I have an AFM result of 4-8 nm but I2D/IG is almost same . Can anyone explain this?

Can we distinguish multilayer graphene with bulk graphite flake? I have an AFM result of 4-8 nm but raman peak intensity ratio I2D/IG is almost same of 0.4-0.5. It shows a shift in 2D peak of...

04 May 2018 3,728 7 View

How to dissolve nitrocellulose membrane to get free-standing graphene film or coated on glass slide after vacuum filtration. ?

Hi, After exfoliation and filtration of layered materials, How to dissolve nitrocellulose membrane to get free-standing graphene film or coated on glass slide ? I read, we need to dissolve it...

31 December 2017 1,729 4 View

How can i model the coordinates of multiple graphene laters?

05 June 2017 775 2 View

Can anyone help me how to model a graphene sheet in abaqus?

05 June 2015 9,860 5 View

Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

What are the new 2D nanomaterials were used for Silver nanoparticles stabilization?

In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...

01 March 2021 2,207 3 View

Why initial concentration of Pb not the same as calculated one when testing using AAS?

I am currently doing research on the adsorption of heavy metal using magnetic reduce graphene oxide. I use AAS to determine the concentration of the heavy metal. I prepare the Pb solution with...

26 February 2021 9,580 4 View

Can anyone share his experience regards Smoothing in origin?

I am working on TiO2 composite material and the results of XRD have a lot of small/junk peaks and while I apply a smooth filter in Origin then the other characteristics peaks disappear so anyone...

26 February 2021 8,183 3 View

No title

I am trying to find how to know the density needed for a pva electrospinning in a 0.6mm neddle, the electrospinning will be from top to bottom and the problem I really have is the solution because...

25 February 2021 2,615 3 View

How does charge on working electrode changes with rising potential?

During performing CV of a GCE or modified GCE, we rise the potential in the first half of the cycle and reduce it in reverse half. During the first half, what is the nature of charge on GCE or...

25 February 2021 7,994 3 View

EMSA troubleshooting. Protein-DNA complex not migrating, cold probe lane with multiple bands. Can anyone help?

I'm running an EMSA to show the DNA binding activity of recombinant proteins versus the Wild type. Previous assays run by my research group using a different test system show the protein-DNA...

24 February 2021 8,325 1 View

How Can I clain a removal of a co-author?

I would like to make a correction in a co-author in your paper which is wrong. This name is also in other papers of Kenton Ko. Zey Ko is not a Co-author . The correct name is Zdenka...

24 February 2021 3,476 4 View

How to delaminate copper in water-based anodes?

Hello everyone, I'm looking for a way to delaminate copper current collector of water-based anodes in Li-ion batteries without damaging the graphite film. I tried different materials such as HNO3...

24 February 2021 3,785 3 View