how do you add a command to enhance air in a solar air heater to be heated up as it flows over the black painted iron sheet when using Ansys Fluent to simulate the solar dryer
Hey, Just for clarification, do you mean boundary condition options with respect to the word command in your question? In that case it depends on the type of geometry you are using. It would be easier for me to help you if give your problem and geometry specifications.
Try using UDF/Schem programming which gives more freedom to control the desired parameters even changing boundary conditions.
the first run I made showed that radiation is received but
1) the absorber plate temperature does not heat up as expected;
2) the air flowing between the absorber plate and the glazing also does not get heated;
yet my intention is to have a system that heats air for drying fruits at about 340K;
- Badges
- Science topic