If the Nimble Setup Manager detects the array then the error is unlikely to be due to the version of the setup manager. Have you set an IP address on the workstation/server that you are running Setup Manager from so its on the same subnet as that of the management IP (i.e 10.1.6.x)? To setup the management IP address via the console the easiest way is run the "setup" command which will run through a wizard to configure the array.
Many thanks for your response. Really, I encountered the error "Sorry, something went wrong in procedure Stack. Value in module GraphStack" in OpenBugs. To tackle this problem, I have switched to Nimble. But, again I get the mentioned error message in Nimble.