Are there commercially available Ni(II)-functionalized quantum dots?

19 September 2017 1 498 Report

QDs should selectively bind histidine-enegineered proteins in water solution. Ni(II) stably attached to the dot's surface or other divalent ions such as Cu(II) or Co(II) could be fine for the purspose. Thanks

Matteo Ardini

thanks Amin

Badges
Science topic

More Matteo Ardini's questions See All

Why am I getting "shark finn"-like signal?

My collegue and I are having hard time to understand what is happening. Basically we have a tapping device that work with Arduino and a pneumatic pump. The pump allows the tapping of two...

04 August 2024 4,662 1 View

Posthoc test lettering in JAMOVI?

Does anyone know of a module for the JAMOVI software that is capable of generating mean separations using the classic letters based on post hoc results (e.g., Tukey test)? If, as I believe, such...

31 July 2024 3,333 4 View

Metallic system in quantum espresso with no smearing. Is this possible?

Hi! I'm simulating a specific material on Quantum Espresso, and I found something strange. Initially I've performed simulations on FCC InAs crystal and I used the Hubbard correction to reproduce...

02 July 2024 9,323 1 View

Can you help me identify Similar Periods in Time-Based Data?

Let's suppose we have a series of time-based data describing a dynamic (e.g., air temperature over the year, measured once a day). Is it possible to apply a statistical technique that allows me to...

05 April 2024 1,591 2 View

How do you call an outcome if you have multiple endpoints to investigate it?

Hello, When you want to investigate exacerbations (outcome of interest) in asthma, you can measure: 1) the incidence rate in the last year (i.e. mean numbers of exacerbations in the last year in...

14 December 2023 9,828 1 View

Does anyone have a recipe for zebrafish aCSF?

Hi everyone, Does anyone have a recipe for zebrafish aCSF that might match the molar concentrations reported by companies like Harvard Apparatus or Tocris (in mM Na 150; K 3.0; Ca 1.4; Mg 0.8; P...

03 December 2023 3,919 0 View

Which statistical test should we use?

Hallo everyone, I need to ask for advice: I am currently doing a research on Carpal Tunnel Syndrome and Ultrasound measurements of the median nerve cross sectional area, in particular I am...

26 September 2023 7,638 0 View

Why do the same PCR products have different weights in the electrophoretic run?

Dear all, Thanking you in advance for your attention, I would like to ask you two questions regarding an electrophoretic run on 2% agarose gel: 1) I did an electrophoretic run of the Real-time...

25 June 2023 7,501 4 View

Which camera should I use for PIV measurements?

Hello everyone, I am working on my Phd on free surface water streams with conda effect. Basically I am acquiring images from above of a rectangular basin in which enters a jet which is then...

22 June 2023 5,089 0 View

How can I delete an article page?

Dear RG staff I'm Simone Seghetti. I'm writing to you for an issue about an article which I had incorrectly uploade (following...

18 April 2023 9,797 3 View

How to calculate CCS for Sodiated adduct ions and Multiply Charged Ions?

I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...

08 August 2024 8,329 0 View

Are there any commercially available Donkey anti-Alpaca secondary antibodies?

Are there any fluorescently labeled anti-Alpaca secondary antibodies raised in Donkey? So far I have only been able to find anti-Alpaca secondaries raised in Goat. Or is this not possible due to...

04 August 2024 4,255 1 View

In the presence of VERY high concentration (1000 ppm) of silicon, the adsorption isotherms of arsenic are showing anomalous trends, why so?

I conducted an adsorption experiment of arsenic on soil in the presence of different doses of silicon as competing ions to see the effect of silicon on arsenic adsorption and desorption. I took 5...

03 August 2024 6,500 3 View

The use of data from PubChem for commercial purposes?

Hi, I'm curious to know if data on chemical compounds from PubChem, such as water solubility properties, can be used to train a machine learning model for commercial purposes. Will this infringe...

30 July 2024 8,707 1 View

How can microbial engineering techniques be used to enhance the functionality and efficacy of probiotics ?

through genetic modification or metabolic engineering? Is it helpful, good for health ?

22 July 2024 7,811 4 View

What is human-computer interaction (HCI)?

22 July 2024 10,056 2 View

How to determine LOD values?

I am performing fluorescence experiments using a ligand to detect metal ions. I want to determine the Lowest Detection Limit (LOD) using the formula LOD = 3σ / K. However, I'm uncertain about...

19 July 2024 1,086 1 View

I'm conducting a study on Research Commercialization in Pakistani HEIs and would appreciate your participation in a brief survey?

Dear Participants- Faculty and Researchers from Pakistani Higher Education Institutions, Thank you for participating in research study that aims to 'Analyze Individual and Institutional Factors...

18 July 2024 7,024 1 View

How to determine the position of occupancy of the dopant? - whether it is doped in tetrahedral or octahedral site?

Suppose a material "A" has both tetrahedral and octahedral sites and we are doping another material "B" - usually an ion into it. How can we detect if the dopant has occupied the octahedral site...

17 July 2024 4,299 4 View

Hello, please if any researcher work in ion battery help me,?

I need to plot cycle number vs. capacity with multicurrent density. please let me know if my steps are right or not as the below picture

14 July 2024 7,702 2 View