05 May 2016 1 6K Report

Students have turned to refer local publishers books as test books.

More Janak Valaki (PhD)'s questions See All
Which vegetable plant seed has the highest oil yield?

I am looking for a guidelines on the vegetable plant which bears highest oil yield.

08 September 2019 1,392 4 View

How to calculate life cycle impact for a manufactured product?

I have not come across any paper where it is systematically stated about how to calculate life cycle impact of a product manufactured using any process. if any one has idea or paper, kindly let me...

07 August 2016 1,454 5 View

What are the direct and indirect benefits of pursuing a PhD program?

During our formal conversations, many of my colleagues and friends used to tell me what are the direct benefits of pursuing and having a PhD degree? i could figure out some of them. But i thought...

06 July 2016 7,815 3 View

Which are the criterions for safe disposal of waste water from vegetable dehydration industry?

are there any criterions laid down by government of india or by any regulatory body worldwide for te safe disposal of waste water from vegetable dehydration industry? which are he technologies...

06 July 2016 9,376 8 View

What are the industrial means to recover the water from mist air?

are there any technology available to recover the water from the mist air or evaporated water mixed air?

05 June 2016 9,934 1 View

Are engineering students really interested in engineering? Is engieering education following BA , BCOM and Bsc route of downfall?

It has been observed that students are interested in matters other than studying engineering. they are preparing for either GATE, GRE. TOFEL, GCET, CAT, UPSC or state level competivie exams.

04 May 2016 2,911 0 View

Can anyone help me or suggest me on how to calculate carbon footprints for steel rolling industry?

I want to understand the exact procedure to be used for calculating carbon foor prints of steel rolling industry. 

04 May 2016 4,506 1 View

How to prevent thickening of the vegetable oil as transformer oil under working conditions?

are there any process to be applied on the oils? or if at all we can't prevent it, then what are the methods available to remove the thickened mass from the remaining oil and reuse the left over oil?

01 February 2016 7,288 1 View

Similar questions and discussions
Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

Is there anyone with experience in TEM analysis who can assist with a manuscript for an upcoming journal?

Hello dear colleagues, We have prepared a manuscript on NiTi-based alloys and are seeking a second opinion on our current TEM results. If you are a Ph.D. holder with experience in TEM and have...

07 August 2024 9,563 0 View

Hello Everyone ! I'm looking for a good journal to publish my manuscript with low publication cost?

I am Looking for a Science Journal with good impact factor and low publication cost to publish a review paper. Your suggestions would be appreciated.

06 August 2024 6,796 3 View

What is the prepared reference material that can be used in inductively coupled plasma optical emission spectrometry (ICP-OES) to measure REE and U ?

What is the prepared reference material that can be used in the ICPE-9820 Shimadzu Japan instrument, which employs inductively coupled plasma optical emission spectrometry (ICP-OES) to measure...

06 August 2024 1,896 1 View

Is an invitation to join the editorial board of Clinical Cardiology Updates a scam?

I received an e-mail invitation to join the editorial board of Clinical Cardiology Updates. While I have published a few articles related to cardiovascular disease, there are lots of colleagues...

06 August 2024 8,981 8 View

Why is the Protocol for Preventing Postpartum Hemorrhage (https://pubmed.ncbi.nlm.nih.gov/36113283/ ) not being widely adopted?

If the placenta is delivered in squatting position within 3 minutes of the birth of the baby, postpartum hemorrhage is completely eliminated. It works every time. It is quite likely that if a...

05 August 2024 8,895 0 View

Do you know any references for analyzing stochastic fiber orientaion composites ?

Hello everyone I am looking for one or some books for propertes and behaviors of stochastic fibre orientation composites. unfotunately I could not find any suitable reference for thias by...

04 August 2024 3,461 3 View

How do i get an account to upload my published papers?

need to open an account to upload my published papers

01 August 2024 9,255 1 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close