Are microplate seals out there that are breathable and optically clear?

07 March 2022 0 6K Report

For my project I need to measure the OD600 of my bacterial cultures over time in 96 wells plates, but due to technical reasons my plates must be sealed. Therefore, I need a seal that allow gas exchange to keep the microbes alive while being optically clear (enough) to measure optical density. Is there a seal that can be recommended for this purpose?

Badges
Science topic

More Ben Nannings's questions See All

How to improve results of system identification procedure?

Hello, I'm performing system identification of the lateral closed-loop dynamics of a quadrotor. My model receives a setpoint and should return position and acceleration. I've proposed a second...

07 February 2021 9,791 2 View

What is the maximum time duration allowed between photoresist coating and exposure?

I have coated the Silicon wafer with photoresist (AZ1518) but until the exposure (Laser Writer) I had to wait for more than a week (Laser Writer was not operative) - would the photoresist still be...

03 January 2021 9,640 4 View

What would happen if all nitrogen atoms in DNA were replaced by Carbon atoms ?

The DNA molecule is in the form of a double helix, The atoms which compose it are carbon, nitrogen, hydrogen, and phosphorus

02 January 2021 4,402 3 View

Which is more important for a journal? The impact factor or the quartile ranking?

I always found confusing both concepts! Which one do you think is more important? I give an example: The journal of "Theoretical and Applied Climatology" has an impact factor of 2.88, but it's a...

01 December 2020 8,608 19 View

Who can collaborate with us?

Salam (Hello)! We have prepared some new compounds with important potential to inhibit viruses. We are interested in inhibition of Hepatetis-B/C, Nipah, Nil and coronavirus. Who can collaborate...

22 November 2020 3,850 14 View

What is the most effective way to transfect HAP1 cells?

I am starting a project with the HAP1 cell line and previously our lab has had difficulty to transfect them. -we have nucleofection equipment - but have only been getting ~10% transfection -i...

19 October 2020 5,340 2 View

What effect do epidemics have on cerebral physiology?

How trauma and fear of infection can affect brain functions and structures?

10 October 2020 6,642 1 View

What are the XRD analysis conditions of the cement, sand and Limestone ?

I am a Phd student and I need to do XRD analysis on my pouder samples namely ( cement- sand- limestone and calcined clay). I was asked asked to specify the analysis conditions: -the nature of...

07 October 2020 5,737 6 View

Why I couldn't obtain a gel from APTES? Does the Amine group affect the gelation process?

I am trying to make a gel from APTES as a precursor using the sol-gel reaction. I tried different solvents (ethanol, acetone, DMF) and different catalysts (basic and acidic) with different...

03 October 2020 9,673 5 View

Best meta-analytic approach with Mean, SD, Sample size for regional values of MRI measure?

I'm interested in evaluting the evidence in the literature I've collected for spatial/anatomical variation in an MRI measure. The data consists of mean values, standard deviations and sample...

14 September 2020 8,910 1 View

Any research papers for extraction of nutrient deprivation on macroalgae? Analysed by HPLC-UV and GC/MS. Possibly from macroalgae genus Rhizoclonium?

I am doing my thesis on the nutrient deprivation on the macroalgae Rhizoclonium sp. I will be analysing the levels over a period of roughly 5 days by HPLC-UV and GC/MS. I will be using seawater as...

28 February 2021 6,477 1 View

Necessary tube lenght to cool Natural gas in a dry-ice cooling bath?

I have a tank which contains natural gas at 250 Bar and 293 Kelvin. I want to cool the gas in a dry-ice cooling bath to about 195 Kelvin. The gas will flow in a copper-tube through the bath with a...

27 February 2021 8,128 1 View

Exit velocity of natural gas from pressurized tank?

Hi Guys. I'm a mechanical engineer and have a bit trouble, would be very glad if you could help me with my questions. I have a pressurized tank which contains Natural Gas at 200 Bar and 293...

26 February 2021 6,253 3 View

Gas sensor response and recovery time independant of flow rate and chamber volume?

I am trying to obtain the response and recovery times for my gas sensor device. It appears the the response/recovery times are primarily dependant on the flow rate of the gas I inject into the...

26 February 2021 1,511 3 View

Why do a weight decrease for thermal degradation in nitrogen gas condition?

Hi all The question is related to TGA(Thermogravimetric analysis). Thermal degradation easily understood but why do samples weight decrease? altough just binding is broked, the weight of...

26 February 2021 1,100 5 View

Why do the air flow results vary totally when adding scalar in CFD ?

Dear All, We are using Autodesk cfd to calculate the air flow in a single sided naturally ventilated room, where air flow depends only on buoyancy due to temperature difference between inside and...

25 February 2021 9,602 4 View

How to dissolve cross-linked Amberlite IRC120 H, hydrogen form resin?

Hello all, I have used Amberlite IRC120 H, hydrogen form acidic cation-exchange resin for the ion-exchange of waterglass [sodium silicate solution -- 40% Sodium silicate (mol ratio > 3.2)...

21 February 2021 5,614 3 View

Aspen Plus Error: Unknown or undefined bead number?

Hello, in my Aspen Plus Simulation (see attachment) there are two heat exchangers. One HEX1 (oil+gas) ist fed by hot gas which ist coming out of a burner. The other HEX2 (gas+gas) shall work as a...

14 February 2021 8,096 2 View

NVT or NPT is preferable for gas adsorption simulation ?

Hi there, In order to perform molecule dynamic simulation on gas adsorption on substrate materials, NVT or NPT ensemble is preferable ? Thanks!

08 February 2021 173 1 View

A film coverage that allows for transmittance of wavelengths on the infrared scale?

I've landed on needing some type of highly optically transparent film or cover material that prevents evaporation of culture media; I am not sure which subfield of materials science would be able...

08 February 2021 5,760 1 View