Anyone can tell me what is the growth velocity of the nuclei of silicon and germanium when it start to grow and reach the final grain form?

More Ahmad Nadeem's questions See All

Could you recommend some articles on Urban Transportation System optimization and Innovation?

13 August 2024 2,595 3 View

Using OBD technique i am trying to measure laser induced shockwaves velocity i found that at start velocity increases and then decay?

i am unable to interpret why its increases in start as shown in figure

11 August 2024 2,179 1 View

Is there any cases algae not using the nutrient from the wastewater and grow normally?

I am working on microalgae cultivation using waste water. The initial concentration of nutrients were less but the microalgae has achieved biomass growth of 2 g/L. The final concentration of...

08 August 2024 4,812 2 View

1. If I can quantize the atom using this hyperbolic spiral and classical physics, could nature do the same?

If we map as a continuous motion an ionising electron (beginning its journey at n=1) in an H atom, a specific hyperbolic spiral appears (see animation). When we solve this spiral formula, we find...

07 August 2024 5,343 2 View

Gromacs first step of minimization ?

I have face this problem anyone help me how to solve this issue ?which is below Fatal error: There are inconsistent shifts over periodic boundaries in a molecule type consisting of 78 atoms. The...

07 August 2024 2,598 1 View

How can I find the cracked version of ENVI-met software?

Envi-met software

07 August 2024 8,188 1 View

Articles on" Gender disparities i leatherwork education"?

Articles on" Gender disparities i leatherwork education"

07 August 2024 2,500 0 View

"A Markov-like Model for Patient Progression"?

A Markov-like Model for Patient Progression" Markov Chain Monte Carlo (MCMC) Markov Chain Monte Carlo (MCMC) is a powerful computational technique used to draw samples from a probability...

05 August 2024 10,079 0 View

Why results of ROS flurescence are negative as there was no bacteria within?

Hello. I am working on ROS production of two systems: system A is cerium oxide and hydrogen peroxide, system B is cerium oxide nanoparticle, hydrogen peroxide and potassium bromide. I did some...

04 August 2024 5,974 3 View

What should I do with parameters that are not relate to my simulation in MyLake model?

I want to Estimate surface heat fluxes using MyLake, but I don't have all the initial values in model parameters section and other sections,is there a way?

04 August 2024 1,537 1 View

Same Schottky barrier height, different dark currents in graphene/semiconductor Schottky contacts ?

I am attempting to comprehend the performance of graphene/n-type semiconductor Schottky diodes in photodetector applications. Given that silicon (Si) and germanium (Ge) have similar electron...

10 March 2024 7,848 1 View

In XRD pattern of germanium film i found FWHM decreases with annealing temperature while intensity also decreases with increase in temperature?

I have grown germanium film on glass coated with copper. deposited films were annealed at various temperatures. the FWHM decreases (indicating Crystal size increses) while intensity also decreases.

05 December 2023 8,846 2 View

What are some metals that can be used to pre-sputter that Ge will adhere with to prevent Ge flaking?

We do Germanium sputter depositions and have found that the Ge flakes off of the surroundings after many depositions. We know there are some metals which can be pre-sputtered that the Ge can stick...

07 August 2023 5,786 3 View

Graphite is an conductor of electric current or a semiconductor ?

Graphite is an allotropic modification of carbon, therefore it is a non-metal. In general, non-metals do not conduct electricity. Carbon is from the same group as silicon and germanium. It can be...

18 April 2023 4,776 3 View

[LAMMPS] How/Where can I get a potential for Germanium-Arsenic and Silicon-Arsenic interaction?

I am planning to simulate the diffusion of As atoms (as dopants) within a growing Ge layer. The system can be pictured as a flux of As and Ge atoms being deposited on a Silicon substrate. The...

29 March 2023 1,458 1 View

How to find built in potential in a diode with two different materials?

If we have a diode with p-type (Germanium) and n-type ( Silicon), then what will be the formula to find the built in potential?

08 March 2022 1,822 3 View

Hello to everyone. does anyone know how to enable non-parabolic correction for germanium in silvaco?

Non-parabolic correction is an important parameter for the materials such as Ge and III-V.

24 October 2021 2,504 3 View

Metal color value (Lab*) data base online available?

Hello, I am very frequently searching for color values as L*a*b* of metal films, typically optically dense on solid substrates, does anybody know if there is a free access date base for such...

20 May 2021 4,881 2 View

Hi everyone, can you help me with these questions? it's about Hall Effect expriment?

Calculate the carrier concetration for a P-type Ge semiconductor of thickness 0.3mm. Determine the hall coefficient for a typical N-type Germanium semiconductor having thickness 0.5mm. Determine...

30 March 2021 5,342 2 View

How to improve the adhesion between germanium and silicon monoxide thin film layers using EBEAM evaporation?

I want to deposit multilayer coating of germanium and silicon monoxide on silicon wafer using ebeam evaporation?

21 February 2021 2,493 3 View

Len Leonid Mizrah

Dear Ahmad Nadeem,

Take a look at the following data:

https://www.mdpi.com/2073-4352/10/1/18/htm

https://www.sciencedirect.com/topics/chemistry/czochralski-process

https://www.nrel.gov/docs/fy02osti/31442.pdf

Also, review the following auxiliary data:

https://www.microchemicals.com/products/wafers/silicon_ingot_production.html

https://www.proquest.com/openview/c9b3050db421c7d8e1da9b7c11e7ac86/1?pq-origsite=gscholar&cbl=18750&diss=y