Hello everyone
I am running a thermo-mechanical simulation on a Linux Cluster.
In my Project view all the component systems seem to have solved. There is a file.rst file and and solver.out files in the solver directory as well. But somehow when i open mechanical, the individual simulation say "solve required".
How can i fix this ?
Mechanical lost its link to get access to .rst file. If you don't have access to the backup files then you definitely need to run the analysis back again in Mechanical. Workbench shows that it is done, because it is not updated. The moment you refresh the project then you see that the green check mark is gone unfortunately and update is required.
Hi I found the solution to this issue with some help from the Ansys Forum.
You can click on Solution and then choose 'Read Result file' from toolbar at the top. You can read the existing file.rst. This should update the status of the solution to the 'solved'.
- Badges
- Science topic
- Similar topics
- Biological Science
- Histology
- Fixatives