I simulated a push-out experiment Of a timber-concrete-combined- ceiling system In Abaqus. as an result I need a force-displacement curve. The calculation stopps after the failure. But I need to see the further displacement. I added the load with an amplitude. time steps 0, 0.01, 0.02, ….., 1 and the force linear to that (divided by 100).
so I have the added force and get the displacement but the calculation stops at like step 0.65.
any idea how to solve this problem?
thank you for your help!
Dear Marie Brunauer,
There are two ways to get results of the post-failure behavior:
First, you must do a simple Buckle analysis, then use the “Static, Riks” step to analyze your model and observe the post-failure behavior.
Second, you can use the Explicit solver for the post-behavior analysis from the start.
Refer to this link: https://caeassistant.com/product/abaqus-for-beginners-structural-engineers-in-the-field-of-civil-engineering/#1607781682465-1198a244-fd69
It will help you not only in your current problem but also in your future problems.
Best luck.
- Badges
- Science topic