Chemical reaction in which monomeric components are combined to form POLYMERS (e.g., POLYMETHYLMETHACRYLATE). | Contact experts in Polymerization to get answers
1,239 views 2,753 posts
Questions related to Polymerization
In recent days Clarivate removed IJERPH [MDPI journal] from Web of Science. Thus, this journal left its IF. Are papers published in past years (when IJERPH was fully listed in Web of Science, JCR...
22 March 2023 8,573 2 View
I'm working on theoretical polarization curves for PEM fuel cells and I found a problem with my model. Theoretically, with higher operation temperatures, the polarization curves should obtain...
17 March 2023 7,608 0 View
What are the Scale dependent & non dependent parameters in Coating process ?
15 March 2023 4,422 13 View
I did some DFT calculations with Gaussian 16 by using mix basis set and I forgot to create a checkpoint file .chk. Is there any way to create ?
15 March 2023 4,815 5 View
any interested you can help me
14 March 2023 1,747 2 View
It should be noted that the method used for the determination of total sugar is : phenol -Acid sulfuric method).
12 March 2023 6,468 0 View
This image shows the result of TG/DT analysis of Co 0.8Mn 0.2Fe 2 magnetic nanoparticles. what is the reason for this linear behavior of TG analysis as well as the peak at 800 degrees of DTA analysis?
07 March 2023 2,541 1 View
TFA
02 March 2023 9,923 4 View
I'm going to buy a table top freeze dryer. Checking the prices I see that the BioBase freeze dryer model BK-FD10P is affordable. Can anyone tell me about this one?
28 February 2023 3,790 3 View
I would like to run M100 tensile test on beamed EPDM rubber samples per ASTM D412-06 (different beam conditions) to determine mechanical strength of crosslinked rubber. I know for...
22 February 2023 6,840 2 View
Dear all, I was puzzled by my present TEM results: PTA staining showed a significant low frequency of AAV empty capsids compared with that of UA staining. I used the same sample and conditions...
16 February 2023 3,580 3 View
Debye Scherrer equation for calculating the crystallite size is given by = / (1) where K is the Scherrer constant, λ is the wavelength of light used for the diffraction, β the “full width at...
16 February 2023 366 3 View
I have been told that because the DSC peak represents heat capacity (Cp) it should and cannot go below the zero mark as the temperature increases. But I have curves that go below the zero mark -...
16 February 2023 9,858 6 View
Hi, Can a co-author be added as a new Corresponding Author in the proof time? Can a journal prevent the paper from having two Corresponding Authors? The journal forces authors to have one CA for a...
10 February 2023 10,003 3 View
Hello, I've been working with a 3D SLA printer to produce a bone tissue scaffold and trying different parameters, both the ceramic slurry and the 3D printer. However, I haven't achieved successful...
08 February 2023 3,144 6 View
I would like to know how varying the applied voltage affects impedance measurement using an Autolab workstation.
03 February 2023 5,094 6 View
In polymer entrap method, the ratio of PVA to cation salts (i.e., nitrates) in the solution was adjusted in such a way that there were 4 times more positively charged valences from the cations...
03 February 2023 7,105 0 View
The resulting film became brittle or two-phases.
02 February 2023 389 3 View
I get this error message. Can you suggest how to clean that capillary?
30 January 2023 9,919 0 View
I have results from TGA of RDF samples, And I need to simulate the experiment. Is it possible to use CFD? I need to show the concentration of the result gases and mass yield of the sample. Did...
27 January 2023 657 1 View
I am looking for a lab that is able to scan cultured cancer cells using Atomic Force Microscopy (AFM). Our lab is located in Rockville, MD. We can ship cells if necessary.
26 January 2023 9,697 0 View
I used the software Mountains8 of the SEM JSM-IT 500 (JEOL company) to create the 3D reconstructed images. Because my field is in MIcrobiology and for first time I tried to measure roughness I...
24 January 2023 4,091 5 View
I am performing invitro bioactive test for polymer scaffold. Is it necessary to change the SBF medium every week
21 January 2023 768 2 View
Dear RG Family, I am working on certain aluminide-based coating systems for anti-corrosion applications. I performed different electrochemical tests including EIS and Tafel after immersion in 3.5...
18 January 2023 1,155 5 View