13 Questions 15 Answers 0 Followers
Questions related from Varadaraju Magesh
I have to mark very very small (0.001 mm) permanent dot on steel specimen as a reference point.
05 May 2018 6,683 7 View
Need to bond Stainless steel orthodontic bracket on steel bar and twist the archwire for 50 degree.It should not get debond during archwire twist.
11 November 2017 1,153 1 View
Need to rotate 10000 nodes to 5 degree, 10 degree upto 50 degrees.
10 October 2017 7,685 0 View
Planned to attach a C clamp like stiff wire on 0.482 mm x 0.64 mm rectangular dental archwire. Is there any possibility? Constraint is that C clamp must with stand applied force (Rotation)...
06 June 2017 5,876 1 View
When we twist a bar inside a slot bar had contact on slot walls. Problem is bar is penetrating inside the wall. How to avoid. Contacts were made in Hypermesh, analysis done in ansys apdl.
09 September 2016 9,621 3 View
Need to find at what load plastic deformation takes place.
09 September 2015 7,474 0 View
I did multiple load steps with ansys transient, after some time when i applied zero force, my model gives some deflection, but within elastic limit, i think that deflection (DMX) should be zero,...
09 September 2015 9,161 7 View
I wish to do loading and unloading through ansys. i able to do transient time load step but i dont know how to do reverse loading?
06 June 2015 4,840 4 View
I have ansys results of my model. I wish to know whether plastic deformation happens in the model due to force.
06 June 2015 9,384 5 View
I have a solid model imported from hypemesh. The orientation of global coordinate system is inclined (x,y,z). when I apply any force/moment it goes along the direction of coordinates not the...
07 July 2014 7,834 5 View
Time varying load step.
06 June 2014 4,314 9 View
Time varying load step - Should you use the reduced or full method?
06 June 2014 5,891 1 View
Transient analysis
06 June 2014 472 2 View
