Sudhir Bisen

10 Questions 8 Answers 0 Followers

Questions related from Sudhir Bisen

How to calculate Evaporator outiside air outlet temperature ?

Dear All, This problem from the evaporator design.We know the Inside evaporating fluid properties and temperature. Outside flowing fluid is Air. We have following unknow parameters :- 1. Air...

09 September 2018 2,296 0 View

Hey, Anyone have experience in two phase condensation modelling in inclined tube using ANSYS FLUENT ?

hello everyone, I'm trying to simulate condensation model using ANSYS FLUENT. The problem domain is constant wall temperature (Tw) heat pipe and steam entering at saturation temperature(Ts). This...

04 April 2016 5,810 2 View

How can i set multi-phase simulation for heating pipe erosion problem in fluent ?

Hello everyone, i want to simulate a boiler pipe erosion problem in ANSYS-FLUENT. Here i'm using Discrete phase modelling. how can i set the different parameter specially in Discrete phase...

06 June 2015 9,139 0 View

How do I measure an internal blockage in a large-diameter pipe externally?

hello everyone, I want to know about the measuring the blockage inside the pipe from externally. Thank you

06 June 2015 6,672 5 View

How to done modelling of condensation in circular pipe by VOF method ?

hello, I have on energy equation in FLUENT but problem is how set input temperature of steam ? Thanks

04 April 2015 4,678 3 View

How do I setup the simulation in FLUENT for multiphase condensation modelling with heat transfer through the wall ?

hello Fluent user, I have a problem in ANSYS FLUENT to simulate the multiphase condensation modelling with heat transfer. The problem domain is a concentric pipe with counter flow arrangement....

04 April 2015 4,679 3 View

How do I calculate amount of condensation in FLUENT ?

hello FLUENT user, please anyone tell me how to calculate amount of condensation in FLUENT? I have done 3-D simulation (evaporation & boiling ) on FLUENT but i don't known how to calculate net...

03 March 2015 8,986 1 View

How do you set processes and nodes in Fluent 15 launcher?

actually I have a problem to use full RAM capacity of my personal computer. fluent launcher a have set process 8 and running the simulation. I have 32 GB RAM but performance show by CPU usage...

01 January 2015 5,615 4 View

I have a problem to convergence of fluent result ?

This problem (3D heat transfer problem ) energy and continuity line are not going down, they are fluctuating.what should i do .. ?

12 December 2014 1,482 2 View

How can I calculate pressure drop across the bundle of a single row air cooled steam condenser ?

i need analytic design calculation of ACSC (air cooled steam condenser).anyone have idea..??

12 December 2014 1,466 3 View