12 Questions 9 Answers 0 Followers
Questions related from Sridhar Sahoo
Can I supply 12V DC voltage to diesel engine glow plug through a MOSFET Switch module.
04 June 2023 7,955 1 View
I had a plan to run the GDI injector for a single pulse injection. This injector draws high current and voltage for its operation. For that I used a GDI injector, Arduino Atmega 2560, Motor...
18 February 2023 222 4 View
What is the mechanism of fuel and oxidizer mixing used in ISRO's designed VIKASH Rocket engine?
05 July 2022 9,713 2 View
I am simulating natural gas direct injection spark ignition engine. The gas injection starts at 360° CA. The simulation time step reduces with the advance in crank angle and in the end simulation...
06 April 2021 4,450 0 View
Knock integral ?
22 February 2020 5,431 3 View
Currently vehicles use natural gas Port fuel injection system for SI engine, and lots of research is going on for direct injection system development but still not yet achieved. Apart from this...
18 January 2019 5,801 5 View
Does Diesel-RK requires any license for installation ? Is it possible to use this for 3 dimensional investigation of engine combustion ?
16 January 2019 6,431 1 View
I presume KH-RT and model used in CFD (in my case FORTE) is used for liquid fuel injection, which thereafter models liquid gas interaction and finally combustion model comes into the...
19 September 2017 4,953 1 View
What is the significance of mach number, pressure and velocity variation profiles? I read a lot of papers on spray modeling using different software packages like Kiva, Star CD etc. what's the...
20 June 2017 3,248 3 View
How to model a gas (methane-air) jet behavior in a constant volume chamber with quiescent air present over it. what strategy will be used for simulating gas injection? and what will be the...
26 May 2017 441 3 View
Recently, I was simulating the tutorial file "SIEngine_PortInjected_AMG_Tutorial.ftsim". After the simulation completed I got some results. I have some basic questions that make me doubt the...
01 January 1970 6,270 1 View
In a constant volume chamber, we did 6 hole nozzle injector to simulate gas (methane) injection simulation. As part of the inlet boundary condition, we used velocity inlet boundary condition (i.e....
01 January 1970 8,019 3 View
