12 Questions 8 Answers 0 Followers
Questions related from Prachi Deshpande
Hi, I have mass and stiffness matrices from ansys in HB form and I converted them in Matlab sparse matrix form. But mass matrix is in terms of Degrees of freedom (DOF) and the total deformation...
04 April 2016 2,204 1 View
Hi, I am doing 2 way system coupling analysis using Workbench for transient structural and fluent. I want to analyse the response for 10 sec and it takes 10 days to get that with current...
03 March 2016 9,400 0 View
HI, I am modelling 2D airfoil under pitch and plunge motion in ansys workbench. I need to model one torsional spring and one vertical linear spring on the 2D airfoil. I am modelling torsional...
01 January 2016 9,231 2 View
HI, My system consists of 3D airfoil in fluid domain. In CFD post, I am trying to get pressure data on the specific point for all time steps. I have defined a point and trying to set up transient...
12 December 2015 532 4 View
HI, I am modeling fluid structure interaction using ansys workbench. I need to get deformation results in the excel sheet with all time steps together. Right now I can get excel sheet with only...
11 November 2015 4,235 0 View
HI, I am analyzing a fluid structure interaction using system coupling in Ansys Workbench. The structural model is similar to a 3D airfoil and air is the fluid medium. I created "Fluid Structure...
10 October 2015 9,287 5 View
I have set up 2 way system coupled Fluid structure interaction using Ansys Workbench system coupling module. I am getting these errors and can not proceed further: Following are the errors: 1....
08 August 2015 8,190 3 View
I am modelling 2 way system coupling using ansys workbench R16. After both the systems are connected, the simulation shows following errors: Error: in read_thread_svar! Error reading "| gunzip -c...
08 August 2015 6,773 0 View
I have built up geometry in Ansys apdl and imported .iges file to Ansys workbench. When I set up system coupling interface, the geometry is shared between transient structural and fluent module....
08 August 2015 9,322 3 View
I have completed geometry and meshing in Ansys apdl, and now want to export the model to Ansys Workbench. I created both .cdb and .iges files from Archive option of ansys apdl. .cdb file opens...
07 July 2015 9,066 2 View
I have a 3D model with extended bar. At the end of that bar, I have to model a torsional spring to adjust the rotational mode frequency.(about X axis of model) I am using ANSYS apdl for modelling...
06 June 2015 2,691 6 View
I have modeled a 3D aircraft wing in ansys apdl. There are 8 airfoils in the geometry. I need to change the mass moment of inertia of those sections using a point mass attached to the section. I...
04 April 2015 459 6 View
