Neha Khairkar

12 Questions 11 Answers 0 Followers

Questions related from Neha Khairkar

Solution not converged, run continued at user's request in ansys apdl?

Why does my error file shows this warning message continuously but the solution is still going on? The error picture is attached

01 January 2018 4,272 1 View

What could be the reason that the model takes more time to solve for nonlinear properties in apdl?

Hello, I am solving a RC wall model and I have observed that if I do the analysis for some time, then with only the linear properties, it is solved faster but as soon as I give a nonlinear...

01 January 2018 8,246 2 View

What are the Constants of concrete of solid 65 element?

Hello, I want to use all the 9 constants of concrete for solid 65 . Where can get all the values for these parameters as the first four are always used so I have the idea about that but how the...

01 January 2018 5,704 3 View

How to rectify the error of too much element distortion in apdl?

I'm performing the analysis of shear wall with foundation 76*27*16 inches and the wall of dimension 48*144*4 inches in apdl. When the displacement controlled lateral cyclic loading is applied on...

01 January 2018 1,205 1 View

While modeling of RC shear wall that subjected to cyclic loading in ANSYS , analytical results differs from experimental results ?

I am working on a verification of RC shear wall subjected to cyclic loading using ANSYS APDL 14.50 but the results given by ansys are far different from that of the experimental results. - I used...

12 December 2017 3,612 2 View

How can I get reaction solution for by constrained nodes at every time step in ANSYS apdl?

I m performing analysis of shear wall which is constrained at the bottom and I have obtained the results. But in order to plot the reaction solution of the nodes at every time step, It has become...

12 December 2017 7,040 1 View

What can be done if there is local failure in model in apdl?

In my model during analysis, there is seen a local failure near the area where the load is applied so I tried using a load plate but it still doesnot work. 1. What can be done to rectify this ? 2....

12 December 2017 2,116 0 View

How do use bauschinger effect in ansys apdl?

I am applying a displacement controlled loading on a shear wall, I am using drucker prager parameters in the material properties, I want to capture the bauschinger effect. How can I do that in...

11 November 2017 9,553 2 View

Where will I find the values for the parameters of Drucker Prager model?

Can anyone suggest some papers where I would find values of cohesion, dialatancy angle of concrete to be used for drucker prager model in ansys?

09 September 2017 3,460 0 View

How to integrate the reaction forces on all nodes in ansys apdl?

For a cantilever beam with point force at end, I have analysed by apdl and got different reaction forces at different nodes (at the fixed point). how to get the single value of reaction force?

08 August 2017 9,283 6 View

What is convergence depended upon in ansys apdl?

I am currently solving a rc beam in Ansys. I have done everything perfectly and checked it many times but it always shows the error that solution not converged at a particular time and some load...

06 June 2017 7,029 0 View

What are the IS codes for the design of RC wall?

is the attached file valid for the design?

05 May 2017 4,032 0 View