17 Questions 55 Answers 0 Followers
Questions related from Muhammad Sajjad
I am scanning CV curves using 3M Na2SO4 electrolyte in Ag/AgCl, Pt mesh and Phos-COF as my positive electrodes, respectively. Every time it gives me straight line at 0. Why this happens?
01 January 2020 3,819 0 View
How we can explain this ...
03 March 2019 7,500 3 View
How we can determine the proper value of current density that i should apply to this system? What is the general procedure to select suitable current density to that system which i mention above....
03 March 2019 9,755 2 View
I am using 3M KOH as electrolyte with Pt counter as counter and Ag/AgCl as reference electrode for my system.with increasing current density why potential is increases? Is this is unusual behavior...
02 February 2019 9,564 4 View
The graph between number of cycles with respect to specific capacitance
01 January 2019 9,106 0 View
I am using the desired setup for CCD in my work. my question is, what does these value corresponds to how much current in ... A/g?
01 January 2019 5,240 3 View
Is its a normal behavior? If not, then any reason, any comments, suggestions will be highly appreciated
01 January 2019 631 6 View
I want to use NCS/CNT as cathode and Carbon fiber paper (CFP) as anode for supercapacitor assembly and i want to widen the potential window. My question is; what is the criteria to take anode...
12 December 2018 7,877 0 View
NiCo2S4 with 6M KOH electrolyte with Ag/AgCl used as reference electrode
09 September 2018 2,619 4 View
I need 7000 cycles but which one i run for numbers of cycles as i mentioned above Thank You
04 April 2018 9,478 1 View
I am using 6M KOH electrolyte and tested the behavior of Ni foam without pressure and with pressure. I observed that, with no pressure (without press Ni foam) the current is very high as compared...
04 April 2018 3,814 7 View
if yes, then what is the difference between the two binders?
03 March 2018 5,689 0 View
In the graph, at low temperature, the resistance of TiO thin film is higher and as temperature decreases the resistance going to decrease and at higher temperature again increases so HOW WE CAN...
09 September 2017 5,745 0 View
this is the equation which shows the resistance in the metallic phase in metals ρ = αT-α eβT My question is what does this equation tell's us about the resistance dependence in metallic...
07 July 2017 5,265 0 View
Kindly suggest me any theory or explanation behind this behaior of YBCO????? Room temperature reflectance experiment. How can i explain the following behavior od YBCO ????? any suggestion or...
04 April 2017 6,858 3 View
attach is the graph
04 April 2017 9,150 4 View
attached is the graph of YBCO (reflectivity vs temeprature)
04 April 2017 2,972 13 View