9 Questions 5 Answers 0 Followers
Questions related from Mehmet Safa Aydoğan
In ABAQUS/Standart there is Full Newton Method among the solution techniques. What deos Full Newton Method means? It means that "Incremental Iterative Newton Raphson Method" or "Newton Raphson...
09 September 2016 2,628 0 View
09 September 2016 3,221 0 View
I have performed a simple 3D cantilever beam analysis in ABAQUS/Explicit. I carry out a major tensile force at the end of the beam, so i can see the fracture. In other words, the beam is divided...
06 June 2016 4,847 3 View
Does Abaqus software calculate stiffness matrix and mass matrix again and again in per step when a nonlinear dynamic analysis be performed. If the answer is yes, then the software must exclude the...
06 June 2016 4,757 4 View
How can be determined the value of "Maxps Damage" and consequently "fracture energy parameter of Damage Evolution" for concrete in ABAQUS?
06 June 2016 6,011 2 View
Dear All, I am modelling reinforced concrete structure by using concrete damaged plasticity model. I apply seismic loads. But when I increase the applied load, the displacements and stresses are...
05 May 2016 7,458 3 View
Hi! I use Drucker-Prager yield criterion in Abaqus for concrete. There are "angle of friction" and "dilation angle" parameters in there. As far as I know, angle of friction resembles Mohr-Coulomb...
12 December 2015 9,003 6 View
Hi, I want to simulate nonlinear dynamic analysis in ABAQUS and i will use "Concrete Damaged Plasticity" in my model. I want to know how to determine the value of "dilation angle, eccentricity,...
12 December 2015 8,662 8 View
I want to run statical analysis. But i can't assign hinge. Can anyone help me please? Thanks in advance.
10 October 2015 1,030 1 View
