18 Questions 5 Answers 0 Followers
Questions related from Lana Agbaria
is it true to say that the mechanical properties (tensile strength and stiffness) are mainly affected by the collagen volume fraction, while the failure strain/compliance are affected by the...
19 January 2025 6,584 1 View
I did biaxial tensile test on collagen reinforced alginate with a small strain rate. how would the results change if i changed the strain rate (higher and smaller)
19 January 2025 7,526 3 View
I have a collagen reinforced hydrogel speciemen, when preconditioing i noticed that the cycles shift to the right why does it happen
10 November 2024 4,549 1 View
I have a stress strain curve of a hyperelastic material, and I am interested in the area under the curve. how can I caluculate it? I have the points data
30 October 2024 1,993 0 View
I have a stress strain graph of a preconditioned soft tissue specimen (3 cycles of loading-unloading), what information can I get from this graph? quanitative and qualitative information
28 October 2024 1,184 0 View
deep core levels have a high binding energy and a low kinetic energy,
29 September 2024 8,478 2 View
for a bio-composte material, where the fibers are orineted with x-axis what would be difference between biaxial and uniaxial loading in stress strain curve ?
25 September 2024 9,858 3 View
..
24 September 2024 4,589 2 View
there were 3 peaks instead of 2. it might be possible that some of the NH2 groups were oxidized during processing. - Using the given information, which N is possible for each peak, Including the...
24 September 2024 7,729 3 View
If we are looking at an oxide film and want to measure its band gap, which of the two methods(xps/auger) will give us more information about the bulk and which will be more surface sensitive?
22 September 2024 145 2 View
Where can we find the electron energy loss information in AES? and where can we find the electron energy loss information in XPS? If we are looking at an oxide film and want to measure its band...
21 September 2024 9,721 2 View
how can I calculate the penetration depth of the measurement in both cases?
21 September 2024 423 5 View
Te3d and Cr2p have nearly the same binding energy: Te3d5/2 – 573 eV, Cr2p3/2 – 574 eV Te3d3/2 – 583 eV, Cr2p1/2 – 583 eV We have to decide which element is present in a certain system and...
21 September 2024 9,541 1 View
names of MNN, MMN, and NNN Auger transitions and their peak width
21 September 2024 4,560 1 View
peak indexing and structure determination but how exactly?
19 August 2024 6,404 2 View
what methods/ analysis does it include?
19 August 2024 544 2 View
What qualitative analysis i need to perform before doing the quantative analysis?
18 August 2024 8,064 1 View
a general question, not a specific phase
17 August 2024 2,501 3 View