14 Questions 14 Answers 0 Followers
Questions related from Hiba al-adhami
Nice Greeting, I am trying to figure out how could trigger the data acquisition due to an external applied pulse load by specify a specific threshold "pre triggering time"? I appreciate any...
31 December 2016 4,080 6 View
Nice Greeting, I have many odb files, and for each file I have to extract the results(time vs acceleration ) report for specific points in my model... I wonder if there is a way could accelerate...
19 April 2016 4,855 3 View
Nice Greeting, I have four curves with different number of points because each curve was calculated according to special condition ... how could I calculate the average of these four curves,...
18 April 2016 1,295 3 View
Nice Greeting , I have four vectors each one has different length how could I get the average of these vectors in MATLAB? Thanks in advance
16 April 2016 6,688 7 View
Nice Greeting, could you please advice me a reference regarding to the bulk modulus and damping properties for Air? Thanks in advance
06 December 2015 7,861 3 View
Nice Greeting, could I use MATLAB/simulink to draw the dispersion curve?Thanks
02 December 2015 2,487 1 View
Nice Greeting I am trying to simulate the absorbing boundary (infinite element) in ABAQUS and I use a keywords to write my input file, but I got an error message that the number of element to be...
19 October 2015 5,106 3 View
Nice Greeting.... I am try to sweep a part of the mesh, and then use that mesh as a tamplet to write the input file and generate the mesh by using the ABAQUS keywords, but I faced a problem that...
15 October 2015 8,946 1 View
Nice Greeting, I am try to get a results for a node that have specific distance from the edge of my model, but I could not figure out how could set that node with specific distance? could you...
10 September 2015 7,538 6 View
Nice greeting, I have a model but I could not figure out what is the unit was used during created that model... could you please explain from where could know what is the unites are...
08 September 2015 1,077 6 View
Nice Greeting, I try to simulate a clay soil layer for geotechnical problem by using ABAQUS. I select Mohr-Columb plasticity for (material __mechanical), when I submit the job, I got an error...
14 March 2015 8,683 2 View
Nice Greeting, I try to figure out how I could apply a load (ex: concentrated load) on a specific point of ABAQUS model surface.... could you please assist me to know how to do that? Thanks in...
11 March 2015 5,767 2 View
Nice Greeting, when I created a model I did mistake, and I could not undo to retain back to the right action, could you please assist me to figure out from where I do the undo and redo?
09 March 2015 8,143 3 View
When I tried to analyse any model even a simple model by Abaqus software I got the same error that I mentioned please could assist me?
06 March 2015 1,888 14 View
