12 Questions 19 Answers 0 Followers
Questions related from Erol Bicer
Hello everyone, I am trying to learn the fundamentals of breakage and coalescence modeling in bubble columns, specifically, for air-water systems when the water is at rest. I believe this is one...
20 November 2022 2,844 4 View
Hello, everyone! I am looking for experiments that measured the single bubble growth parameter such as bubble diameter, sliding velocity/length, lift-off diameter for the steam-water case. Any...
27 April 2021 5,845 4 View
Hello, everyone! I am looking for some references and/or experimental data for a system when steam enters into a cylindrical pipe with a very low mass flow rate and condenses in it due to heat...
30 March 2021 7,320 3 View
Hello, everyone! I am doing research on pool scrubbing and I am looking for experiments where a gas (preferably non-condensing) is injected into a pool by a single nozzle. I thought I could...
07 September 2020 7,449 3 View
Is there an image processing technique that I can use to obtain a void fraction distribution in a tank where non-condensible gas is injected into a stagnant liquid?
24 April 2020 2,316 0 View
What are the transition pipe diameters for a small pipe, a large pipe, and a pool? In addition, what is the transition in bubble column reactors? The size of the pipe affects the flow regime so...
09 April 2020 5,527 0 View
Hello everyone, I am looking for some references to understand the flow patterns when high-velocity gas is injected into a liquid tank. I want to see how the flow patterns are changing from...
23 March 2020 9,486 4 View
Hello everyone, I am looking for the contents/samples of following reports. Especially, number 4. Any help would be greatly appreciated. 1. Inception Report (IR) 2. Nuclear Industrial Survey...
03 April 2018 8,863 6 View
I am doing some literature review on condensation with non-condensable gases on-tubes. Especially, the effects of tilting and diameter on HTC. Most of the references are about in-tube...
02 January 2018 9,959 3 View
The below caption is from the fluid film model in STAR-CCM+. I am having difficulties to understand these two criteria about detecting the saturation temperature. Isn't that the first criterion...
29 November 2017 2,500 0 View
Hello fellow researchers, I want to simulate subcooled evaporation phenomenon in a large enclosed tank. The working fluid is water and it's subcooled. It won't come to equilibrium since there is...
24 May 2017 3,456 2 View
Hello everyone, I've been searching about fouling factors in tube banks. Specially, for staggered fin tube bundle type air cooled heat exchanger. I'm aware of the TEMA standards. Any reference...
28 September 2016 4,507 13 View
